Panasonic KV-S2065W Operating Instructions - Page 18

Display Panel Instructions Others menu No. Item LCD display Contents Page 01 Checking the version Version Displays the firmware version of the mechanical control, pre-imprinter or post-imprinter. If an optional imprinter is not installed, the imprinter version will not be displayed. 02 Setting the buzzer Buzzer 03 Setting the SCSI ID SCSI ID Selects whether the buzzer is turned on or off. If selection is in the "ON" position: When pressing a key, one short beep will be heard. When there is an error, 5 short beeps will be heard. When scanning is completed correctly, one long beep will be heard. 27 Sets the SCSI ID number. 04 Setting the terminator Terminator Sets "Enable" or "Disable". "Enable" : If last device on chain. "Disable" : If between devices. 05 Setting the transfer rate Transfer Rate • Changes the maximum value of the synchronous transfer rate of the SCSI interface. • Lower the synchronous transfer rate to 10 Mbytes/ sec. if the computer has failed to recognize the scanner or the scanner fails to operate properly. Checking the roller cleaning warning 06 Clearing the roller cleaning warning Clean Roller Clean Roller The alarm tells you it is time to check the roller. If it is near 100%, clean the roller. See "Cleaning the Unit" on page 36. Clear the "Clean Roller Warning ≤≤%" display. 07 Checking the roller modules replacement Replace Roll. warning The alarm tells you the roller needs to be changed. If it is near 100%, replace the paper feed roller module and retard roller module. See "Replacing Consumables" on page 41. 28 Clearing the roller modules replacement Replace Roll. Clear the "Replace Roll. Warning ≤≤%" display. warning 08 Setting the product ID Product ID Selects the product ID. The product ID setting depends on the host computer scanner application you are using. Allows scanner to emulate other Panasonic scanners. 09 Setting the sleep mode Sleep Mode Sets the time until sleep mode turns ON. 18