Panasonic KX-NT343 Quick Reference Guide - Page 13

Operation Board Angle Adjustment - set time

Page 13 highlights

Operation Board Angle Adjustment Operation Board Angle Adjustment The angle of the operation board can be set to one of eight angles (level 1 = 0°, level 8 = 45°). 8 7654 3 2 1 CAUTION: Hold the operation board until the operation board is secured at the desired angle. Make sure you do not pinch your fingers when raising or lowering the operation board. To raise: Gently lift the operation board one level at a time. To lower: Raise the operation board to level 8. Next, with one hand on the base of the unit, lift the operation board again to release the latch, then slowly push the operation board down to level 1. If the operation board cannot be lowered to level 1, repeat this step. • When a KX-NT305 is attached to this unit, first lift the unit's handset cradle to release the latch (A), then with one hand on the base of the KX-NT305, similarly lift its operation board to release its latch (B). Locking the Handset Hook Pull down the handset hook until it locks to prevent the handset from falling off the handset cradle when the unit is mounted to a wall or set at a high angle. To temporarily place the handset down during a conversation, hook it over the top edge of the unit as shown. Document Version 2007-06 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Operation Board Angle Adjustment
13
Document Version 2007-06
Operation Board Angle Adjustment
O
The angle of the operation board can be set to one
of eight angles (level 1 = 0°, level 8 = 45°).
CAUTION:
Hold the operation board until the operation board is secured at the
desired angle. Make sure you do not pinch your fingers when raising
or lowering the operation board.
To raise:
Gently lift the operation board one level at a
time.
To lower:
Raise the operation board to level 8. Next,
with one hand on the base of the unit, lift the
operation board again to release the latch,
then slowly push the operation board down
to level 1. If the operation board cannot be
lowered to level 1, repeat this step.
When a KX-NT305 is attached to this unit, first
lift the unit’s handset cradle to release the
latch (
A
), then with one hand on the base of
the KX-NT305, similarly lift its operation board
to release its latch (
B
).
Locking the Handset Hook
Pull down the handset hook until it locks to prevent the
handset from falling off the handset cradle when the unit
is mounted to a wall or set at a high angle. To temporarily
place the handset down during a conversation, hook it
over the top edge of the unit as shown.
1
2
3
4
5
6
7
8