Panasonic KX-TGE463S Operating Manual - Page 63
Answering system settings, Turning on the answering system, remotely, Call screening
![]() |
View all Panasonic KX-TGE463S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Answering System for Landline Key *5 *# Operation Erase all messages End remote operation (or hang up) *1 If pressed within the first 5 seconds of a message, the previous message is played. *2 For English voice guidance only *3 For Spanish voice guidance only Turning on the answering system remotely 1 Dial your phone number from a touch-tone phone. 2 Let the phone ring 15 times. R A long beep is heard. 3 Enter your remote access code within 10 seconds after the long beep. R The greeting message is played back. R You can either hang up, or enter your remote access code again and begin remote operation (page 62). Answering system settings Call screening Handset / Base unit While a caller is leaving a message, you can listen to the call through the unit's speaker. To adjust the speaker volume, press MjN or MkN repeatedly. You can answer the call by pressing M N on the handset or MZN on the base unit*1. Call screening can be set for each unit. The default setting is "On". 1 For handset setting: MMENUN#310 For base unit setting (using a handset)*1: MMENUN#*310 2 MbN: Select the desired setting. a MSAVEN a MOFFN *1 KX-TGE470 series: page 4 Number of rings before the unit answers a call You can change the number of times the phone rings "Ring count" before the unit answers calls. You can select 2 to 7 rings, or "Toll saver". The default setting is "4 rings". "Toll saver": The unit's answering system answers at the end of the 2nd ring when new messages have been recorded, or at the end of the 5th ring when there are no new messages. If you call your phone from outside to listen to new messages (page 62), you know that there are no new messages when the phone rings for the 3rd time. You can then hang up without being charged for the call. 1 MMENUN#211 2 MbN: Select the desired setting. a MSAVEN a MOFFN Caller's recording time You can change the maximum message recording time allowed for each caller. The default setting is "3 min". 1 MMENUN#305 2 MbN: Select the desired setting. a MSAVEN a MOFFN Selecting "Greeting only" You can select "Greeting only" which sets the unit to announce a greeting message to callers but not record messages. Select "Greeting only" in step 2 on "Caller's recording time", page 63. Note: R When you select "Greeting only": - If you do not record your own message, the unit will play the pre-recorded greeting-only message asking callers to call again later. - If you use your own message, record the greeting-only message asking callers to call again later (page 58). For assistance, please visit http://shop.panasonic.com/support 63 TGE46x47x(en)_1117_ver061.pdf 63 2015/11/17 15:14:16
![](/manual_guide/products/panasonic-kxtge475s-operating-manual-27d922e/63.png)