Panasonic KX-TGF37 KX-TGF37x Owner's Manual - Page 51
Baby monitor, Setting the baby monitor
View all Panasonic KX-TGF37 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
2 MbN: Select the desired group. a MSELECTN R " " is displayed next to the selected group numbers. R To cancel the selected group: MbN: Select the group. a Press MSELECTN again. " " disappears. 3 MSAVEN 4 Proceed with the operation for your unit. Handset: MOFFN Base unit: MEXITN Baby monitor This feature allows you to listen in on a room where another handset is located, allowing you to easily monitor from different areas of the house or place. The monitored handset (placed in a baby's room, for example) will automatically call the monitoring handset, base unit, or the phone number stored when it detects sound. Important: R You should perform a test run of the baby monitor procedure to ensure that the baby monitor feature is set correctly. For example, test its sensitivity. Check the connection if you are diverting the baby monitor to an outside line. R This feature should not be used as a substitute for a medical or caregiver's supervision. It is the caregiver's responsibility to stay close enough to handle any eventuality. Note: R If the unit is connected to a PBX system, you cannot set the baby monitor. R During the monitoring mode, battery consumption is faster than usual. We recommend leaving the monitored handset on the base unit or charger. R The monitored handset never rings while it is being monitoring. If the base unit is placed near the monitored handset, we recommend turning off the base unit ringer volume (page 47, 48). Programming Setting the baby monitor Perform the setting operation with the handset to be monitored (for example, the handset placed in a baby's room). To monitor with a unit The internal baby monitor feature is only available: - between handsets - between a handset and the base unit Handset 1 MMENUN#268 2 MbN: "On" a MSELECTN 3 MbN: Select the desired unit's number to monitor with. a MSAVEN R "Baby monitor" will be displayed. R The registered unit's name/number is displayed. Note: R When this feature is on, another handset or the base unit can hear the monitored handset by making an intercom call. To monitor from an outside line If you enable this feature, the unit will call a pre-programmed phone number when the handset detects sound. After you answer the call, you can listen in on the room where the handset is located. This feature is only available for landline. Handset n From the phonebook: 1 MMENUN#268 2 MbN: "On" a MSELECTN 3 MbN: Select "Outgoing call" to monitor from an outside line. a MEDITN a MADDN 4 MbN: "Phonebook" a MSELECTN 5 MbN: Select the phonebook entry. a MSAVEN R "Baby monitor" will be displayed. For assistance, please visit www.panasonic.com/support 51 TGF37x(en)_1128_ver032.pdf 51 2014/11/28 16:08:42