Panasonic KXTG2503S KXTG2503S User Guide - Page 3
Making/Answering Calls
View all Panasonic KXTG2503S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Getting Started Section 1 1-D Belt Clip 1-E Wall Mounting You can hang the handset on your belt or pocket using the belt clip. To attach the belt clip This unit can be mounted on a wall phone plate. 1 Adjust the angle of the cradle: #Slide the lock switch to "RELEASE". 1 Back Side $Rotate the cradle 90° until it faces straight up. %Slide the lock switch 3 Back Side to "LOCK" with the cradle facing straight up. 2 3 #Tuck the telephone line cord inside the wall mounting adaptor. $Connect the telephone line cord to the unit. %Install the adaptor by pushing it in the direction of the arrow. •The word "UP" should face upward. 1 To remove the belt clip 2 Connect the AC adaptor. 3 2 To Power Outlet 4 Connect the telephone line cord. Mount the unit, then slide down. •Raise the antennas. 2 Making/Answering Calls Section 2 2-A Making Calls TALK Indicator (TALK) (CH) , (REDIAL) • For best operating performance, see section 6-D. Lighted handset keypad The handset dialing buttons will light when you press a button or lift the handset off the base unit, and flash when a call is received. The lights will go out a few seconds after pressing a button, lifting the handset or answering a call. 1 Press (TALK). •The TALK indicator lights. •If an alarm tone sounds, see 6-F. 2 Dial a phone number. 3 To hang up, press (TALK) or place the handset on the base unit. To redial the last number dialed Press (TALK) \ (REDIAL). To select the receiver volume 3 levels (HIGH, MEDIUM, LOW) are available. Press Ñ or Ö while talking. •Each time you press Ñ or Ö, the volume level will change. If noise interferes with the conversation Press (CH) to select a clearer channel or move closer to the base unit. 2-B Answering Calls If the handset is off the base unit, press (TALK). •You can also answer a call by pressing any dialing button (0) to (9), (*) or (#) (- Any Key Talk). OR If on the base unit, just lift up. Selecting the ringer volume The TALK indicator light must be off. •To select HIGH (preset) or LOW, press Ñ or Ö. Each time you press Ñ or Ö, the ringer volume will change and the selected volume will ring. •To turn the ringer OFF, press and hold Ö until 2 beeps sound. •To turn the ringer ON, press Ñ. The ringer will sound at the HIGH level. •When you replace the battery, the selected ringer volume setting will return to the factory set.