Panasonic LB80U Operating Instructions - Page 30

PICTURE menu Remote control Control panel MENU RETURN COLOR You can adjust the color saturation of the projected image. (Available with signals of VIDEO/S-VIDEO/ YPBPR only) See "Navigating through the MENU" on page 27. See "Main menu and Sub-menu" on page 28. Lighter Darker PICTURE MODE Depending on the projection environment, you can use these preset parameter settings to optimise image projection. Press I H to cycle through the options. NATURAL Reproduces the original color of the image STANDARD Setting for a general image DYNAMIC Bright and sharp setting BLACKBOARD Setting for when projecting on a blackboard See "BLACKBOARD" on page 36. NOTE: • The default setting varies according to the selected signal. • It may take for a while until the selected mode is stabilised. TINT You can adjust the skin tone in the projected image. (Available with signals of VIDEO/S-VIDEO/YPBPR only) More reddish More greenish SHARPNESS You can adjust the sharpness of the projected image and the adjustable range depends on the input signal. Less sharp More sharp CONTRAST You can adjust the contrast of the projected image. Adjust the BRIGHTNESS in advance if necessary. Lower Higher BRIGHTNESS You can adjust the brightness of the projected image. Darker Brighter COLOR TEMPERATURE You can adjust the white balance of the projected image. Press I H to cycle through the options. STANDARD Balanced white HIGH More bluish LOW More reddish DAYLIGHT VIEW You can keep the projected image bright and vivid even in well-lit rooms where the ambient light sources cannot be controlled, such as when a door opens or when window coverings fail to block out sunlight. AUTO: Automatic adjustment ON: Active OFF: Deactive NOTE: • Do not cover the Ambient Luminance Sensor (ALS) of the projector. See "Ambient Luminance Sensor (ALS)" on page 12. • AUTO is not available when INSTALLATION setting in OPTION menu is set to REAR/DESK or REAR/CEILING. Settings ENGLISH - 30