Panasonic NC-EH40 Operating Instructions - Page 21
Clean with Citric Acid
View all Panasonic NC-EH40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Maintenance When scale has adhered Clean with Citric Acid 1 Make sure that the mesh filter is attached to the container. 2 Put citric acid in the inner container. ● Amount of citric acid to be used at one time: 80 g (two packages) or seven level tablespoons. once every two or three months Citric acid The citric acid is available from an authorized dealer. (Model No: SAN-80N) * Follow the directions for cleaning printed on the citric acid package. * Since the citric acid used for cleaning is a food additive, it is harmless to humans. 3 Add water to the maximum water level mark, and mix the citric acid and water well. Close the lid. 4 Connect the plug immediately after stirring and press the key more than 3 seconds. Cleaning start End of cleaning Lit Flashing Cleaning time (approx.) NC-EH40P: 50 Min. NC-EH30P: 42 Min. NC-EH22P: 35 Min. Indications will note when cleaning ends. 5 Dispense some water, then unplug, remove the lid and throw away the hot water via the "DRAIN" mark. 6 Refill with water and boil it to remove the smell of the citric acid or lemons. 5 Then throw the hot water away in the same way as in step . ● To remove any discoloration from the area above the maximum water level, rub the inside lightly with a wet sponge. ● If the discoloration cannot be removed by rubbing, clean the inner container several times using citric acid or lemons. Cautions ● Use only our citric acid to clean this thermo pot. ● Do not fill with water above maximum water level. ● Fill the container only with tap water (do not fill with hot water). Hot water may spout out causing burns. 21 Operating NC-EH40_EN.indd 21 11/7/07 3:57:56 PM