Panasonic P1SDU PTP1SDU User Guide - Page 25
Other Settings, Tv-system, Detailed Setup, Position, Auto Signal
UPC - 791871111253
View all Panasonic P1SDU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
NOTE: B If using this projector in places such as cafes or hotels to display programes for a commercial purpose or for public presentation, note that if the aspect ratio (16:9) selection function is used to change the aspect ratio of the screen picture, you may be infringing the rights of the original copyright owner for that programe under copyright protection laws. B If a 4:3 picture is projected onto a 16:9 screen, distortion may occur around the edges of the picture so that part of the picture is no longer visible. Programes which have 4:3 aspect ratios should be viewed in 4:3 mode to give proper consideration to the aims and intentions of the original programe's creator. POSITION (PC/YPBPR/S-VIDEO/VIDEO only) Moves the picture position. Press the ENTER button to display the "POSITION" screen. HORIZ.3 2 VERT. 1 6 Press the I or H button to move the picture horizontally. Press the F or G button to move the picture vertically. 48-ENGLISH DETAILED SETUP You can adjust the noise and flicker of the projected images. Press the ENTER button to display the "DETAILED SETUP" menu. When a PC/YPBPR signal is being input DETAILED SETUP DOT CLOCK 32 CLOCK PHASE 16 SELECT ENTER RETRN When an S-VIDEO/VIDEO signal is being input DETAILED SETUP STILL MODE OFF ADJ RETRN DOT CLOCK (PC only) Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, press the I or H button to adjust so that any such noise is minimised. CLOCK PHASE (PC/YPBPR only) Adjust the "DOT CLOCK" setting first before carrying out this adjustment. Press the I or H button to adjust so that the noise level is least noticeable. NOTE: B If signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the "DOT CLOCK" and "CLOCK PHASE" adjustments are carried out. STILL MODE (S-VIDEO/VIDEO only) To reduce flickering of still images (vertical flicker), set "STILL MODE" to "ON". NOTE: B Set to "OFF" when playing back moving images. Other settings Press the F or G button on the remote control unit to select an item, and then press the I or H button to change the setting. OTHER SETUP AUTO SIGNAL ON TV-SYSTEM AUTO FRONT/REAR FRONT DESK/CEILING DESK HIGHLAND OFF LAMP RUNTIME 10H SXGA MODE SXGA CTRL PANEL VALID NR OFF SELECT ADJ RETRN AUTO SIGNAL This should normally be set to "ON". ON "AUTO SETUP" will be carried out when the input signal is changed to "PC". OFF "AUTO SETUP" will not function when the input signal is changed to "PC". TV-SYSTEM (S-VIDEO/VIDEO only) TV-SYSTEM AUTO [ NTSC [ NTSC4.43 [ PAL [ PAL-M [ PAL-N [ SECAM This should normally be set to "AUTO". If the signal is of such poor quality that the correct format cannot be automatically distinguished, change the setting manually to the required TV system. NOTE: B When set to "AUTO", the projector automatically distinguishes between NTSC/NTSC 4.43/PAL/PAL60/ PAL-M/PAL-N/SECAM signals. ENGLISH-49 Adjustments and settings