Panasonic PT-F300EA Operating Instructions - Page 58

Technical Information DVI-D IN terminal J Pin assignments and signal names Pin No. Signal name 1 TMDS Data 2- 2 TMDS Data 2+ 3 TMDS Data 2/4 shield 4 5 6 DDC clock 7 DDC data 8 9 TMDS Data 1- 10 TMDS Data 1+ 11 TMDS Data 1/3 shield 12 Pin No. Signal name 13 14 +5V 15 GND 16 Hot Plug Detect 17 TMDS Data 0- 18 TMDS Data 0+ 19 TMDS Data 0/5 shield 20 21 22 TMDS clock shield 23 TMDS clock+ 24 TMDS clock- Ceiling mount bracket safeguards The projector and the ceiling mount bracket are designed sufficiently safety though, make sure the safety cable provided with the projector is installed and attached to the bottom of the projector when mounting on the ceiling for safety and security. NOTE: • Even if it is guarantee period, the manufacturer is not responsible for any hazard or damage caused by using a ceiling mount bracket which is not purchased from an authorised distributors, or environmental conditions. • Make sure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver. • Installation work of the ceiling mount bracket should only be carried by a qualified technician. • Remove an unused ceiling mount bracket promptly. J Installing the safety cable 1. Install the ceiling mount bracket according to the installation instructions. 2. Loop the security cable around the ceiling mount bracket with less slack. Lace the cable of the end with a latch through the loop on the other end of the cable. 3. Attach the latch on to the bottom of the projector with a provided screw. Torque: 1.25±0.2 N·m Appendix * Indicated sample above is ET-PKF100S. ENGLISH - 58