Panasonic PT-LB90NTU Lcd Projector - Page 40

PROJECTOR SETUP menu STANDBY MODE You can change the standby mode setting. Change setting Change setting ECO NORMAL The standby power is reduced to 0.9 W to save power. The power of the projector can be turned ON and the audio output can be set active from controlling the computer connected via a wired LAN or a wireless LAN in the NORMAL mode. LAMP POWER You can adjust the power of the lamp to save electricity, prolong the lamp life and reduce the noise. Change setting Change setting NORMAL ECO When higher luminance is required When lower luminance is sufficient Remarks zzWhen no input signal is detected, this function is disabled. zzThe ECO setting is recommended when higher luminance is not required such as in a small room. LAMP RUNTIME You can check how long the lamp has been used. Note zzLAMP RUNTIME is a relevant matter for lamp replacement timing. See "Replacing the Lamp unit" (Æpage 48). zzCheck the lamp unit replacement time. (Æpage 48) Remarks zzIf the lamp runtime has reached 2 800 hours, the red (time indicator) and gray marks appear alternately to notify you of the lamp replacement time. zzThe lamp life varies with its condition of use (number of power-on times, etc. ). EMULATE When the projector is controlled with a computer through serial input terminal, you can change the setting to use the former projector control commands. 1111 Press the ENTER button. 2222 Press▲▼buttons to select the required setting. 3333 Press the ENTER button. ● DEFAULT D3500 D4000 D/W5K series D/W/Z6K series L730 L780 L735 L785 F/W series LB75 Series LB78 Series LB80 Series LB90 Series D3500 D4000 D5500 Series DW5000 Series D5600 Series DW5100 Series D5700 Series D5000 Series D6000 Series DW6300 Series DZ6700 Series DZ6710 Series L520 Series L720 Series L730 Series L750 Series L780 Series L735 Series L785 Series F100 Series FW100 Series F200 Series F300 Series FW300 Series Settings 40 - ENGLISH