Panasonic PT47WXC43G PT4743G User Guide - Page 6

IN STALLATION Installation Television Location This unit can be used as part of an entertainment center. Consult your dealer for available options. • Avoid excessive sunlight or bright lights, including reflections. • Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure. • Fluorescent lighting may reduce remote control transmitting range. • Keep away from magnetic equipment, including motors, fans and external speakers. Optional Cable Connections Shielded audio and video cables should be used between components. For best results: • Use 75-ohm coaxial shielded cables. • Use appropriate input and output connectors, that match your component connectors. • Avoid long cables to minimize interference. AC Power Supply Cord CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS. Cable / Antenna Connection For proper reception, either a cable or antenna connection is required. Cable Connection Connect the cable supplied by your local cablecompany to ANT1 connection on Incoming Cable from Cable Company back of television. Select ANT1 and Cable mode in SET UP menu. Note: A cable converter box may be required for proper reception. 75 Ohm VHF/UHF on back of TV Check with your local cable company for compatibility requirements. Antenna Connection For proper reception of VHF/UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. • Connect home antenna to ANT1 Incoming Cable from connection on back of television. Home Antenna Select ANT1 and TV mode in the SET UP menu. Note: Cable Mode is preset at the factory. Antenna users must change to TV Mode and ANT 1 in the Set Upmenu. Auto Set Up Menu For your convenience, Auto Set up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures for setting up the features. IDIOMA/LANGUE To change menu language to ENGLISH, SPANISH or FRENCH. Procedure • Press VOL u to select English, Spanish or French. MODE To select TV (antenna) or CABLE mode depending on the signal source. Procedure • Press VOL u to select TV or CABLE. AUTO PROGRAM To automatically program all channels with a signal. Procedure • Press VOL u to start Auto Programming. CONVERGENCE To adjust the center convergence, if needed. Procedure • Press VOL u to display center Convergence adjustment menu. • Refer to page 27 for setting Convergence, if needed. 4 l