Panasonic PT60LC14 Multi Media Display - Page 35

Playing peripheral equipment Confirming connections A video camera uses the Input 3 terminal on the front of the projection display. Example: Connect Input 3 To S-video output or video output Video camera VCR DVD player Basic Operation ECALL To audio output This equipment can also be connected to the rear terminals. See Connections for details. POWER SAP LIGHT TV VCR DVD DTV RCVR DBS/CBL AUX TV/VIDEO A - ANTENNA - B ASPECT E BBE R CH MUT VOL OK VOL MENU CH EXIT 1 2 3 4 7 R-TUNE SWAP REW 5 8 0 SPLIT PLAY 6 9 PROG SPLIT CTRL FF PAUSE STOP REC FREEZE TV/VCR SPLIT CH SEARCH DVD/VCR CH OPEN/CLOSE Turning the power on and switching input modes 1 Turn the projection display on. TV HDMI* 2 Remote Control The input mode changes each time this button is VIDEO 1 * VIDEO 2 * RGB 2* (For PT-50LC14/ PT-60LC14) Unit pressed. VIDEO 3 * * If SKIP is set as the Input Label setting of SETUP, the mode will not be changed. COMPONENT 1 * RGB 1* (For PT-50LC14/PT-60LC14) RGB* (For PT-43LC14) (P. 52) COMPONENT 2 * Card input mode is selected. • Pressing SD again exits Card input mode. COMPONENT 3 * COMPONENT 4 * VIDEO 1 Signal of source connected to INPUT 1 is displayed. VIDEO 2 Signal of source connected to INPUT 2 is displayed. VIDEO 3 Signal of source connected to INPUT 3 is displayed. COMPONENT 1 Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed. COMPONENT 2 Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed. COMPONENT 3 Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed. COMPONENT 4 Signal of source connected to COMPONENT VIDEO INPUT 4 is displayed. RGB 1 (or RGB) Signal of source connected to RGB IN 1 (or RGB IN) is displayed. RGB 2 Signal of source connected to RGB IN 2 is displayed. HDMI Signal of source connected to HDMI IN is displayed. CARD Signal of source connected to CARD SLOT is displayed. 3 Operate the connected equipment. 35