Panasonic PTAE500U PTAE500U User Guide - Page 24
CLEANING AND REPLACING THE AIR FILTER, REPLACING THE LAMP UNIT, Care and maintenance, Warning - bulb
View all Panasonic PTAE500U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Cleaning and replacing the air filter If the air filter becomes clogged with dust, the internal temperature of the projector will rise, the TEMP indicator will flash and the projector power will turn off. The air filter should be cleaned after every 100 hours of use. # Turn off the MAIN POWER switch and disconnect the power cord plug from the wall outlet. Turn off the MAIN POWER switch according to the procedure given in "Turning off the power" on page 24 before disconnecting the plug from the wall outlet. $ Gently turn the projector upside down. & Clean the air filter. Soak the air filter in water and wash out dirt by hand. NOTE: B Place the projector on top of a soft cloth so that it will not become scratched. % Remove the air filter. Put your fingernails under the air filter and pull the air filter out of the projector. Air filter NOTE: B Do not use detergent. B Be careful not to separate the air filter cover from the frame when washing the air filter. ' Dry the air filter and install it to the projecter. NOTE: B Be sure to install the air filter before using the projector. If the projector is used without the air filter installed, dust and other foreign particles will be drawn into the projector, and malfunctions will result. B If the dust cannot be removed by cleaning, it is time to replace the air filter. Please consult your dealer. Furthermore, if the lamp unit is being replaced, replace the air filter at this time also. 46-ENGLISH Replacing the lamp unit NOTE: B If you need the lamp replacement, please purchase the lamp unit from our customer service. Lamp unit product no.: ET-LAE500 CAUTION: B Do not use any lamp unit other than the one with the product number indicated above. Warning When replacing the lamp, allow it to cool for at least one hour before handling it. B The lamp cover gets very hot, and contact with it can cause burns. Notes on replacing the lamp unit B The light generating lamp is made of glass, so dropping it or allowing it to hit hard objects may cause it to burst. Be careful when handling the lamp. B Dispose of the removed old lamp with the same care that would be taken with a fluorescent light. B A Phillips screwdriver is necessary for removing the lamp unit. Lamp unit replacement period The lamp is a consumable product. Even when the full life of the bulb has not been exhausted, the brightness of the light will gradually decline. Therefore periodic replacement of the lamp is necessary. The intended lamp replacement interval is 2 000 hours, but it is possible that the lamp may need to be replaced earlier due to variables such as a particular lamp's characteristics, usage conditions and the installation environment. Early preparation for lamp replacement is encouraged. The lamp will automatically shut off when 2 000 hours of use have been reached because of a much greater chance of it exploding after this time. NOTE: B The usage hours explained above are for use when the "HIGH" setting has been selected for "LAMP POWER" in the "OPTION" menu. If the "LOW" setting is selected, the brightness of the lamp will be less and life of the lamp can be extended. B While 2 000 hours is the intended replacement interval, it is not a period of time covered by warranty. ENGLISH-47 Care and maintenance