Panasonic PTD5500U PTD5500U User Guide - Page 34
Option 2 Settings, Id, Front / Rear, Desk / Ceiling, Lamp Select, Lamp Power
View all Panasonic PTD5500U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
OPTION 2 settings OPTION2 ID ALL FRONT/REAR FRONT DESK/CEILING DESK LAMP SELECT DUAL LAMP POWER HIGH RS232C SYSTEM INFORMATION FAN CONTROL1 NORMAL FAN CONTROL2 HORIZ. FUNC1 LAMP POW AUTO POW. OFF DISABLE PASSWORD SELECT ADJ RETRN ID The projector has an ID number setting function that helps the user to control two or more projectors either simultaneously or separately with a single remote control. The ID number is set to "ALL" by default. Hence the ID number need not be set when only one projector is used. 1-64 : The ID number is set in this range. Note • The ID number can be set to "ALL", or selected from "1" to "64". • If the projectors are given ID numbers, their remote controls must be assigned the same ID numbers, respectively. • If the ID number of a projector is set to "ALL", it can be controlled by the remote control or the PC with any ID number. If multiple projectors are used and some of them have their IDs set to "ALL", they cannot be controlled separately from the projectors with other ID numbers. For details on remote control ID setting, see page 15. FRONT/REAR "FRONT/REAR" is used to choose the appropriate projection scheme from Front and Rear: FRONT : Choose this option if pictures are projected from the front of a reflective screen. REAR : Choose this if pictures are projected from the back of a translucent screen. DESK/CEILING DESK/CEILING is used to choose the appropriate projection scheme from Desk and Ceiling: DESK : Choose this option if the projector is installed on a floor-standing base. CEILING : Choose if the projector is installed on the ceiling using the optional ceiling mount bracket. 34 LAMP SELECT "LAMP SELECT" is used to choose from Single Lamp and Dual Lamp modes depending on user's needs or viewing conditions. In Single Lamp mode, the projector may automatically select either lamp from the 2 lamps, or the particular lamp can be specified. DUAL : Two lamps are used simultaneously. SINGLE : One of either lamps is used (lamp with shorter operating hours is automatically selected). LAMP1 : Lamp Unit 1 is always used. LAMP2 : Lamp Unit 2 is always used. When one of the above settings is selected, it will take effect after ENTER is pressed. Note • If, in the "SINGLE", "LAMP1" or "LAMP2" mode, one lamp remains off or the currently active lamp exceeds 1 500 hours of cumulative operating time (when "HIGH" is selected as the lamp power setting), the other lamp will light. If, in the "DUAL" mode, one lamp remains off or the currently active lamp exceeds 1 500 hours of cumulative operating time (when "HIGH" is selected as the lamp power setting), the other lamp alone will light. However, if both lamps remain off or the 1 500 hours of cumulative operating time are exceeded, the projector will enter the standby mode. • If only one lamp is installed in the projector, set lamp mode to either "LAMP1" or "LAMP2". "LAMP1" or "LAMP2" is selected. If the corresponding lamp is not installed, the other lamp will turn on. The same holds for "LAMP2" mode. • The colors of the items indicate the status. Green Current setting Cyan Now changing from one status to another Red Lamp that has failed to light White Any other status This time period is 4 000 hours when long life lamp units (page 43) are used. LAMP POWER The luminance of the projection lamp can be changed depending on user's needs or the viewing conditions. HIGH : Set when high brightness is necessary. LOW : Set when high brightness is not necessary. Note • When set to "LOW", it is possible to reduce power consumption, reduce operating noise and extend lamp service life. • "LOW" is set automatically when long life lamp units are used.