Panasonic PTD5500U PTD5500U User Guide - Page 35

RS232C This sets the communication parameters at the serial terminals. For details on the serial terminals, refer to "Using the serial terminals" (page 38). IN BAUDRATE : 9 600, 19 200 or 38 400 is selected. IN PARITY : NONE, EVEN or ODD is selected. OUT BAUDRATE : 9 600, 19 200 or 38 400 is selected. OUT PARITY : NONE, EVEN or ODD is selected. VPS SYSTEM : MASTER or SLAVE is selected. GROUP : A to Z is selected. MASTER or SLAVE is also selected. SYSTEM INFORMATION The projector's system information can be viewed. SYSTEM INFORMATION ROM VERSION 1. 00. 00 SET RUNTIME 300h LAMP1 LOW 100h HIGH 200h TOTAL 300h LAMP2 LOW 100h HIGH 200h TOTAL 300h LAMP1 ON 20 LAMP2 ON 20 LAMP1 TYPE LAD55 LAMP1 TYPE LAD55 RETRN FAN CONTROL1 The fan can be controlled in accordance with the operating conditions. NORMAL : Standard setting HIGHLAND : This is selected when using the projector at an altitude of over 1 400 meters. FAN CONTROL2 The fan can be controlled in accordance with the direction in which the images are to be projected. HORIZ. : Standard setting VERTICAL : This is selected when projecting images at a significant angle toward the vertical (more than 30 degrees from the horizontal). V H 30° 30° 30° H 30° V H: HORIZ. V: VERTICAL Attention • Select the correct FAN CONTROL2 setting in accordance with the direction in which the images are to be projected. Using the projector at the wrong FAN CONTROL2 setting will shorten the service life of the lamps. FUNC 1 The user can set the function for the remote control's FUNC1 button. LAMP POW : The button functions in the same way as "LAMP POWER" of "OPTION2". ASPECT : The button functions in the same way as "ASPECT" of "POSITION". AUTO POW.OFF The projector can be automatically set to the standby mode if no signals are input for the set duration. DISABLE : Standard setting. This function is set to OFF. 15MIN.-60MIN.: The duration can be set in 5- minute increments from 15 to 60 minutes. Note • The auto power OFF function does not work while the freeze function is used. PASSWORD This function is used when a service person. Input the password with the numeric buttons (0 to 9) of the remote control and press ENTER button to confirm the entry. 35