Panasonic PTF300NTU PTF300NTU User Guide - Page 41
Projector Setup Menu, Status, Computer2 Select, No Signal Shut-off, Initial Start Up
UPC - 791871111680
View all Panasonic PTF300NTU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
PROJECTOR SETUP menu Remote control Control panel COMPUTER2 SELECT You can switch the function of the COMPUTER2 IN/ 1 OUT terminal. INPUT COMPUTER2 IN OUTPUT COMPUTER1 OUT See "Navigating through the menu" on page 32. See "Main menu and Sub-menu" on page 30. STATUS You can see the status of the projector about the following items. Items Description Q SIGNAL NAME Projecting signal name FREQUENCY Projecting signal frequency Q RUNTIME PROJECTOR Duration of projector used time LAMP Duration of lamp used time Q REMAINING FILTER QUANTITY Quantity of filter remaining APPROX.TIME Approximately time of filter remaining NOTE: • QUANTITY and APPROX.TIME of REMAINING FILTER is not the accurate but the calculated and predicted result based on the filter rolling pace. Incorrect remaining time could be displayed briefly; such as suddenly shortened or stays same for a while. • Replacement of the Auto Cleaning Filter (ACF) needs to be prepared when the QUANTITY and APPROX.TIME of REMAINING FILTER becomes few. NO SIGNAL SHUT-OFF You can set the timer to switch off the power of the projector after a certain period of time automatically when no signal is detected. Press I H to select the required period from 15 to 60 minutes at intervals of 5 minutes. FG 15 MIN. FG 20 MIN. FG 25 MIN. FG 30 MIN. FG 35 MIN. DISABLE IH FG 60 MIN. FG 55 MIN. FG 50 MIN. FG 45 MIN. FG 40 MIN. INITIAL START UP You can select how the projector start when the power cord is connected. Options LAST MEMORY STANDBY ON Description Start as the same mode as the last switched off. Always start in standby mode. Always start in projecting mode. Settings ENGLISH - 41