Panasonic PTP1SDU PTP1SDU User Guide - Page 29
CLEANING AND REPLACING THE AIR FILTER, REPLACING THE LAMP UNIT, Warning, Notes on replacing the lamp - bulb replacement
View all Panasonic PTP1SDU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Cleaning and replacing the air filter If the air filter becomes clogged with dust, the internal temperature of the projector will rise, the TEMP indicator will illuminate and the projector's power will turn off (the TEMP indicator will flash after the power is turned off). The air filter should be cleaned every 100 hours of use. Cleaning Use a vacuum cleaner to clean off any accumulated dust. Replacement procedure # Turn off the power and disconnect the power cord. Be sure to disconnect the power cord by following the procedure given on page 28. $ Gently turn the projector upside down, and then remove the air filter cover. Air filter cover NOTE: B If the dust cannot be cleaned by a vacuum cleaner, remove the air filter and soak it in water, and then wash out the dust by hand. Be sure to install the air filter after it has dried. B Do not use detergent when washing the air filter. B If the dust cannot be removed by cleaning, it is time to replace the air filter. Please consult your dealer. Furthermore, if the lamp unit is being replaced, replace the air filter at this time also. 56-ENGLISH Air filter cover % Replace the air filter, and then install the air filter cover. Air filter NOTE: B Be sure to install the air filter before using the projector. If the projector is used without the air filter installed, dust and other foreign particles will be drawn into the projector, and malfunctions will result. Replacing the lamp unit Warning The lamp unit should only be replaced by a qualified technician. When replacing the lamp, allow it to cool for at least one hour before handling it. B The lamp cover gets very hot, and touching it can cause burns. Notes on replacing the lamp unit B The light generating lamp is made of glass, so dropping it or allowing it to hit hard objects may cause it to burst. Be careful when handling the lamp. B Dispose of the removed old lamp with the same care that would be taken with a fluorescent light. B A Phillips screwdriver is necessary for removing the lamp unit. NOTE: B The projector is not supplied with a replacement lamp unit. Please ask your dealer for details. Lamp unit product no.: ET-LAP1 CAUTION: B Do not use any lamp unit other than the one with the product number indicated above. Lamp unit replacement period The lamp is a consumable product. Even when the full life of the bulb has not been exhausted, the brightness of the light will gradually decline. Therefore periodic replacement of the lamp is necessary. The intended lamp replacement interval is 2 500 hours, but it is possible that the lamp may need to be replaced earlier due to variables such as a particular lamp's characteristics, usage conditions and the installation environment. Early preparation for lamp replacement is encouraged. The lamp will automatically shut off after approximately 10 minutes when 2 500 hours of use have been reached because of a much greater chance of it exploding after this time. NOTE: B While 2 500 hours is the intended replacement interval, it is not a period of time covered by warranty. ENGLISH-57 Care and maintenance