Panasonic PTP1SDU PTP1SDU User Guide - Page 9

Projector control panel #$ %& Illumination sensor and LAMP/ TEMP indicators '( Remote control unit POWER INPUT MENU % ENTER AUTO SETUP 0 STD / SHUTTER RETURN ENTER VOLUME $ ROTATE ) & * + , - . # Input signal indicators These indicators illuminate when a signal is being input to the connector that has been selected using the INPUT button. The indicators flash when no signal is being input to the connector that was selected using the INPUT button and when signals that are not compatible with the projector are being input. 16-ENGLISH $ SD operation buttons (pages 18 and 35) These buttons are used for operation when the SD selection screen is being displayed and when files in the SD memory card are being played back. % POWER button (pages 26, 28 and 29) This button is used to turn the power on and off. This button on the projector illuminates red when the projector is in standby mode, and it illuminates green when a picture starts to be projected. & INPUT button (page 27) This button is used to switch the input signals from the connected equipment. ' Illumination sensor (page 44) This sensor detects the luminance when the "DAYLIGHTVIEW" function is operating. Do not cover the projector and do not place any object on the projector when using it. ( LAMP indicator (page 55) This indicator illuminates when it is time to replace the lamp unit. It flashes if a circuit abnormality is detected. ) TEMP indicator (page 54) This indicator illuminates if an abnormally high temperature is detected inside the projector or around it. If the temperature rises above a certain level, the power supply will be turned off automatically and the indicator will flash. * MENU button (pages 40 and 42) This button is used to display the "MAIN MENU". When a menu screen is being displayed, this button can be used to return to a previous screen or to clear the screen. + ENTER button (page 42) This button is used to accept and to activate items selected in the on-screen menus. , Arrow (FGI and H) buttons (page 42) These buttons are used to select and adjust items in the on-screen menus. - SHUTTER button (page 31) This button is used to momentarily turn off the picture and sound. . VOLUME +/- buttons (page 31) These buttons are used to adjust the volume of the sound output from the projector's built-in speaker. / STD (standard) button (page 43) This button is used to reset the projector adjustment values to the factory default settings. 0 AUTO SETUP button (pages 27 and 30) If this button is pressed while a PC signal is being projected, the position of the image and the settings for "DOT CLOCK" and "CLOCK PHASE" will be adjusted automatically. ENGLISH-17 Preparation