Panasonic PV-L452 Vhs-c - Page 41
Pc Connection - camcorder software
UPC - 037988976874
View all Panasonic PV-L452 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
PC Connection Special Features Digital PhotoShot Software A live or captured image can be transferred to your PC (Personal Computer). Before you begin... • Turn your PC off. • Set Camcorder POWER to OFF. System Requirements for Digital PhotoShot • IBM PC/AT or compatible. • Intel Pentium Processor. • Microsoft Windows95 or Windows98 or WindowsMe or Windows2000. • RAM: 16 MB or more. • 2 MB of available hard-disk space. • 256 color monitor (full color recommended). • 3.5 inch 1.44 MB floppy disk drive (for installation). • RS-232C serial port (D-Sub 9-pin). An adaptor (D-Sub 9-pin male to a D-Sub female) is required for a D-Sub 25-pin. • Mouse or other pointing device. PC-Camcorder Connection Connect Camcorder PC jack to the serial port on your PC (Personal Computer) using the supplied PC connector cable. Refer to PC or Windows manual to identify which COM port to be used for connection. Note: • Be sure to turn PC off before connection for proper image transfer. • After Camcorder and PC are connected by starting up the software included, video recording is not possible. Software Installation (Windows 95/98/Me/2000) RS-232C Serial Port (Default is COM1) (D-Sub 9-pin) PC Connector PC Connector cable (supplied) Before you begin... • Your PC is in the power on mode. 1 Turn on PC (Personal Computer) and start up Windows. 2 Insert Digital PhotoShot disk (Windows 95/98/Me/2000) into a floppy disk drive. 3 Click on Start, then "Run..." 4 Type in "a:\setup.exe" and click OK. • If your 3.5 inch floppy disk drive is not "A", use appropriate letter. 5 Follow instructions as they appear on PC screen until the installation is complete. • Setup window will disappear when the installation is complete. 41