Panasonic PV27D52 PV27D52 User Guide - Page 10

Initial Setup (Ready to Play) Please make all cable or antenna connections before powering on. Connecting For ANT./Cable Connect the cable from Antenna/Cable to the VHF/ UHF terminal on the unit. For DSS/Cable Box Connect the OUT jack on your cable box to the VHF/ UHF terminal on the unit with a RF cable. UNIT PV-27D52 Rear shown. VHF/UHF VHF/UHF IN from ANT./CABLE Cable TV Converter Box WARNING: Overtightening "Nut type" RF coaxial cables may damage jacks. Finger tighten only. VHF/UHF VHF/UHF IN from ANT./CABLE Initial Setup (Ready to Play) 1 Plug the unit power cord into an AC wall outlet. 2 Press POWER* on the remote or unit. The unit comes on and auto channel and clock set starts. 3 Settings are made automatically. When setup is done, this screen appears. 2/ 6/2002 WED 12:00PM DST : ON SETT ING : CH 10 AUTO CLOCK SET COMPLETED CH AUTO SET PROCEEDING • If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off. If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page. AUTO CLOCK SET I S I NCOMPLETE AUTO CLOCK SET PROCEEDING PLEASE SET CLOCK BY PRESSING ACT I ON KEY CANCEL : PRESS STOP KEY 10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail : [email protected]