Panasonic RP-BT10-K RPBT10 User Guide - Page 25

Troubleshooting Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem: refer to the "Panasonic / Technics Accessory Limited Warranty" on page 29. Take the unit when you visit your dealer. Problem Possible cause and suggested remedy I can't hear any sound. The sound is barely audible. I hear a lot of noise. The sound keeps breaking up. •Something is wrong with the wireless communication. •Is power being supplied to the unit and device connected to it? (Is the unit's lamp blinking in blue?) •Have you temporarily suspended play using the receiver or iPod®? •Has the transmitter been inserted all the way into the docking connector of the iPod®? •Is the transmitter's connector dirty? •Has the input plug of the stereo earphones been inserted all the way (into the AUDIO OUT connector)? •Is the plug dirty? •Noise may be heard due to the effect of the cellphone. •Depending on the specifications and settings of your cellphone, the sound may break up or data communication may not be possible when you operate your cellphone. •Is a Bluetooth-enabled device other than this unit being used? Do not use the two devices at the same time. The unit doesn't work. •Has the battery in the receiver or the device connected discharged? If it is, recharge it. •No power is supplied while the unit is being charged. •Connect the transmitter firmly to your iPod®, and reset the receiver. (The pairing information is not erased by this operation.) Then perform the pair setting again. * Reset operation: Insert a paper clip or other thin rod-type object into the hole on the receiver and press until there is the feeling of a button being pressed. I can't register the (pairing of the) device. •Did you allow more than one minute to elapse after setting the unit to the device registration mode? The pair setting is automatically released if you allow more than one minute to elapse. •Set the pairing with the unit and connected device placed as close to each other as possible. I can't use my cellphone •Is your cellphone set to auto response or answering machine mode? to communicate. •Have you set the volume level for the incoming tone and for receiving calls too low? RQT8993 25