Panasonic RXD27 RXD27 User Guide - Page 6

Listening to radio broadcasts Normal tuning 2 134 Preset tuning Preset the stations (20 FM and 12 AM) to make tuning simpler. 2 1 1 Press [TUNER/BAND -AUTO PRESET] to select "FM" or "AM". (Unit comes on.) ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 2 (Omit this step if using the remote control) If " " is on the display, press [TUNE MODE] to clear it. ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 3 Press [- / ] or [ / +] to tune to the desired station. Automatic tuning Press and hold [-/ ] or [ /+] then release when the frequency display starts to change. A station with good reception is automatically selected and the process stops. To stop automatic tuning, press [-/ ] or [ /+] again. Note Automatic tuning may stop on a frequency where there is no station if there is interference. Press [-/ ] and [ /+] to tune if this occurs. ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 4 Adjust the volume. To improve reception FM: Extend the whip antenna and adjust its direction. AM: Adjust the position of the unit. If noise is excessive in the FM stereo mode Press [PLAY MODE] on the remote control. ("MONO" lights up.) Sound will be produced in monaural, but this also reduces noise. Press the button again to cancel. ("MONO" goes out.) 2 13 RX-D29 RX-D27 Automatic presetting Do the following once each for FM and AM. Preparations: Press [TUNER/BAND -AUTO PRESET] to select "FM" or "AM". Press and hold [TUNER/BAND -AUTO PRESET] on the main unit until "AUTO" is displayed. The tuner presets stations it can receive into the channels. Manual Presetting Remote control only Presets one station at a time. ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 1 Press [PGM/CLEAR]. ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 2 While " " is flashing (about 10 seconds) Press the numbered buttons to select a channel. To select channel 10 or higher e.g.12: [=>10] → [1] → [2] ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Repeat the above to preset other stations. The station occupying a channel is erased if another station is preset in that channel. To listen to preset channels 1 Press [TUNER/BAND -AUTO PRESET] to select "FM" or "AM". ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 2 (Omit this step if using the remote control) Press [TUNE MODE] to display " ". ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 3 Press [- / ] or [ / +] to select the desired channel. (FM:1-20, AM:1-12) Remote control: [ / ALBUM]( PRESET TUNE) or [ALBUM / ](PRESET TUNE ) Preset channel 6 RQTT0585