Panasonic SAHT790V SAHT790V User Guide - Page 15

5 STEP Plug-in Auto Tuning DVD/VCR FM/AM REC Í DVD/VCR DVD VCR TV TUNER RESET TV/VIDEO PAGE GROUP PICTURE MODE/ SETUP REPEAT PLAY MODE 1 4 7 100 2 3 5 6 8 9 S10/ENTER 0 VCR SKIP SLOW/SEARCH TV VOLj TV VOLi JET REW OPEN/CLOSE/EJECT TOP MENU NAVI DIRECT NAVIGATOR CH MENU PLAY LIST ENTER OSD/DISPLAY RETURN CH VOLUME D.RE-MASTER C.S.M C.FOCUS S.POSITION SUBWOOFER SFC SUPER SRND MUTING POSITION MEMORY PROG [SHIFT] SUBTITLE CANCEL SLEEP ÎPL ZOOM QUICK REPLAY SPEED AUDIO TEST MIX 2CH CH SELECT MENU POWERÍ/I POWERÍ/I VCR EJECT REC TIMER REC /REW FF/ STOP PLAY CH X CH W CH CH PROGRESSIVE SELECTOR STOP PLAY DOWN OPEN/CLOSE DVD VOLUME UP PHONES After plugging the unit into your household AC outlet and pressing [Í] to turn the unit on for the first time, the unit automatically tunes in all the channels it can receive and sets the clock. The unit determines the type of transmission, TV or CATV, as follows: TV: when there are less than 5 CATV channels. CATV: when there are 5 or more CATV channels. Preparation ≥Confirm that the antenna is connected correctly. ≥Turn on the television and select the video input for the VCR. ≥Press [VCR] to put the remote control in VCR mode. Press [Í] to turn on the unit. Plug-in Auto Tuning starts and the unit puts the stations it can receive into channels (➡ page 43, Channel range). 2 AUTO CHANNEL SET PROCEEDING END :MENU The unit starts auto clock setting when finished, then displays the time. [Note] If auto tuning stops partway (by changing the source, turning the unit off, or due to a power failure.) 1 Disconnect the AC power supply cord on the main unit and then reconnect it. 2 Turn on the main unit. To cancel partway Press [MENU]. ∫ To start Plug-in Auto Tuning again (after relocation, for example) Preparation ≥Press [Í] to turn on the unit. ≥Make sure there is no video cassette tape loaded in the unit. ≥Press [DVD/VCR] to select "VCR" as the source. 1 Press and hold [CHX] and [CHW] on the main unit simultaneously for 3 seconds until the channel changes to "2". Disappears 2 2 Disconnect the AC power supply cord on the main unit and then reconnect it. 3 Turn on the main unit. Plug-in Auto Tuning restarts. Antenna system and channel captions all revert to the default values when you perform the procedure above. Reset the timer recording settings. (If necessary reset the clock first. ➡ page 42, CLOCK SET) ∫ To set the channels manually (➡ page 43). ∫ If the unit couldn't set the clock automatically The MANUAL CLOCK SET screen appears. Set the time manually (➡ page 42). RQT6951 15