Panasonic SC-GA10 Owners Manual - Page 19

Firmware updates The following status indicators keep lighting up in orange. Error indications The status indicators (l 7) show one of the following blinking patterns in orange. An error has occurred. Disconnect the AC power supply cord from the AC outlet, reconnect it to the AC outlet after about 30 seconds. The unit will try to update again. Network Cannot connect to the network. ≥ Make sure that the multicast function on the wireless router is enabled. ≥ This unit's Wi-Fi security does not support WPA2-Enterprise. For details on the security supported by your router and how to change the settings, please refer to the Owner's Manual for the router or contact your Internet service provider. Cannot select this unit as the output speakers. ≥ Make sure that your devices are connected to the same network as this unit. ≥ Reconnect your devices to the network. ≥ Turn off and then on the wireless router. Playback does not start. The sound is interrupted. ≥ If using the 2.4 GHz band on the wireless router, simultaneous use with other 2.4 GHz devices, such as microwaves, cordless telephones, etc., may result in connection interruptions. Increase the distance between this unit and these devices. - If your wireless router supports 5 GHz band, try using the 5 GHz band. To change to the 5 GHz band, redo the network setup to select your network name for the 5 GHz band. ≥ Do not place this unit inside a metal cabinet, for it might block the Wi-Fi signal. ≥ Place this unit closer to the wireless router. ≥ If several wireless devices are simultaneously using the same network as this unit, try turning off the other devices or reducing their network usage. ≥ Reconnect the devices to the network. ≥ Turn off and then on the wireless router. ≥ There is a problem with this unit. Disconnect the AC power supply cord from the AC outlet, reconnect it to the AC outlet after about 30 seconds. If the problem still persists, disconnect the AC power supply cord and consult your dealer. 19 TQBJ2056