Panasonic SC-HC295 Owners Manual - Page 15
Remote control code, System memory reset
View all Panasonic SC-HC295 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
█ Main unit displays "--:--" • You connected the AC power supply cord for the first time or there was a power failure recently. Set the clock. Track play time is more than 99 minutes. "ADJUST CLOCK" • The clock is not set. Adjust the clock. "ADJUST TIMER" • The play timer is not set. Adjust the play timer. "AUTO OFF" • The system has not been used for 20 minutes and will turn off within a minute. To cancel, press any button. "ERROR" • An incorrect operation was done. Read the instructions and try again. "F61" "F77" • Disconnect the AC power supply cord and consult your dealer. "F703" • Examine the Bluetooth® connection. • Disconnect the Bluetooth® device. Turn off the system and then turn on again. "F76" • There is a problem with the power supply. • Disconnect the AC power supply cord and consult your dealer. "ILLEGAL OPEN" • The sliding door is not in a correct position. Turn off the system and then turn on again. "NODEVICE" • The USB device is not connected. Examine the connection. "NO DISC" • You have not put in a disc. "NO PLAY" • Examine the content. You can only play supported format. • The system may have a problem. Turn off the system and then turn on again. "PLAYERROR" • You played an unsupported MP3 file. The system will skip that track and play the next one. "REMOTE 1" "REMOTE 2" • The remote control and the main unit are using different codes. Change the code of the remote control. - When "REMOTE 1" is shown, press and hold [OK] and [ ] for a minimum of 4 seconds. - When "REMOTE 2" is shown, press and hold [OK] and [USB/CD] for a minimum of 4 seconds. "SOUND 1 NOT SET" "SOUND 2 NOT SET" "SOUND 3 NOT SET" • You have not saved the sound effects into the sound setting number. "USB OVER CURRENT ERROR" • The USB device is using too much power. Disconnect the USB device, turn off the system and then turn on again. "VBR" • The system cannot show the remaining play time for variable bit rate (VBR) tracks. Remote control code When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system. Preparation Press [USB/CD] to select "CD". █ To set the code to "REMOTE 2" 1 Press and hold [SELECTOR] on the main unit and [USB/CD] on the remote control. "REMOTE 2" is shown. 2 Press and hold [OK] and [USB/CD] for a minimum of 4 seconds. █ To set the code to "REMOTE 1" 1 Press and hold [SELECTOR] on the main unit and [ ] on the remote control. "REMOTE 1" is shown. 2 Press and hold [OK] and [ ] for a minimum of 4 seconds. System memory reset Reset the memory when the following situations occur: • There is no response when buttons are pressed. • You want to clear and reset the memory contents. 1 Disconnect the AC power supply cord. 2 While you press and hold [1] on the main unit, connect the AC power supply cord again. Continue to press and hold the button until is shown. 3 Release [1]. All the settings are set back to the factory preset. It is necessary to set the memory items again. 15 TQBJ2048 ENGLISH