Panasonic SC-HC400 Owners Manual - Page 7

Inserting media ∫ Connecting a USB device ≥ Insert the USB device directly. Do not use any USB extension cable. ≥ Please disconnect the USB device if you finish using. ≥ Before removing the USB device, select a source other than "USB". ∫ Inserting a CD The label side ≥ Make sure to tilt the disc so as not to touch the sliding door. ≥ Do not open the sliding door manually. ∫ Charging a device Charging starts when a device (rated value: 5 V/1.5 A) is connected to the USB port of this unit. 1 Turn the unit on. 2 Connect a device. {. Confirm from the screen of the connected device, etc. to make sure charging has started. To the compatible device USB cable (not supplied) ≥ A cable compatible with your device is required. Use the cable that comes with your device. ≥ Even if you connect a cable compatible with the USB port of this unit, your device may not be charged. In that case, use the charger that comes with the device. ≥ Depending on your device, using other chargers may not work. Check the operating instructions of your device before use. ≥ Do not connect a device with a rated value higher than 5 V/ 1.5 A to this unit. ≥ To check if charging is complete, look at the screen of the connected device, etc. ≥ Once fully charged, remove the USB cable from the USB port. ≥ After the device has started charging, you can turn the unit to standby mode. - When charging a depleted device, do not turn the unit to standby mode until the device becomes operational.  ≥ Make sure that the unit does not fall when inserting or removing media. ≥ When moving this unit, be sure to remove all media and turn this unit to standby mode. 7 TQBJ2049