Panasonic SC-PM600 Owners Manual - Page 10
Clock and timers
View all Panasonic SC-PM600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
█ Selecting a preset station 1 Press [PLAY MENU] repeatedly to select "TUNEMODE". 2 Press [R, T] to select "PRESET" and then press [OK]. 3 Press [2/3] or [5/6] to select the preset station. Improving the sound quality 1 Press [PLAY MENU] repeatedly to select "FM MODE". 2 Press [R, T] to select "MONO" and then press [OK]. To cancel, select "STEREO". "MONO" is also canceled when you change the frequency. To memorize the setting Continue with step 4 of "Manual presetting". Checking the signal status Press [DISPLAY]. FM - - - - FM ST FM MONO The FM signal is weak. The system is not tuned in to a station. The FM signal is in stereo. "MONO" is selected as the "FM MODE". The FM signal is in monaural. FM allocation setting This system can also receive FM broadcasts allocated in 0.1 MHz steps. 1 Press [RADIO]. 2 Press and hold [RADIO/USB] on the main unit. After a few seconds, the display panel shows the current minimum radio frequency. Release the button when the minimum frequency changes. • To go back to the initial setting, do the above steps again. • Preset frequencies are erased after you change the setting. Clock and timers Setting the clock This is a 12-hour clock. 1 Press [SETUP] repeatedly to select "CLOCK". 2 Press [R, T] to set the time and then press [OK]. To check the time Press [SETUP] repeatedly to select "CLOCK" and then press [OK]. In standby mode, press [DISPLAY]. Note: Reset the clock regularly to maintain accuracy. Play timer (Except for Bluetooth® source) You can set the timer to come on at a certain time to wake you up. Preparation Set the clock. 1 Press [SETUP] repeatedly to select "TIMER ADJ". 2 Press [R, T] to set the start time and then press [OK]. 3 Do step 2 again to set the end time. 4 Press [R, T] to select the source you want to play and then press [OK]. To start the timer 1 Press [SETUP] repeatedly to select "TIMER SET". 2 Press [R, T] to select "SET" and then press [OK]. "#" is shown. To cancel, select "OFF". The system must be switched off for the timer to operate. To check the setting Press [SETUP] repeatedly to select "TIMER ADJ" and then press [OK]. In standby mode, press [DISPLAY] two times. Note: • The timer starts at a low volume and increases gradually to the preset level. • The timer comes on at the set time every day if the timer is on. • If you switch off the system and then switch on again while a timer is in operation, the timer will not stop at the end time. RQT0B23 10