Panasonic SC-PM600 Owners Manual - Page 5

ENGLISH Making the connections Connect the AC power supply cord only after all the other connections have been made. Placement of speakers 2 (6:) (6:) 3 1 1 Connect the FM indoor antenna. Place the antenna where reception is best. Adhesive tape (not supplied) 2 Connect the speakers. Red B Black A Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. 3 Connect the AC power supply cord. To household AC outlet Do not use an AC power supply cord from other equipment. Conserving power The system consumes a small amount of power (Z"Specifications") when it is in standby mode. Disconnect the power supply if you do not use the system. Some settings will be lost after you disconnect the system. You have to set them again. The left and right speakers are the same. Use only the supplied speakers. You can cause damage to the system and decrease the sound quality if you use other speakers. Note: • Keep your speakers at least 10 mm (1332") away from the system for proper ventilation. • Put the speakers on a flat safe surface. • To prevent damage to the speakers, do not touch the speaker cones if you remove the nets. • These speakers do not have magnetic shielding. Do not put them near TVs, PCs or other equipment easily influenced by magnetism. • When you play at high levels for a long period, it can cause damage to the speakers and decrease the life of the speakers. • Decrease the volume in these conditions to prevent damage: - When the sound is distorted. - When you adjust the sound quality. CAUTION! • Use the speakers only with the recommended system. If not, you can cause damage to the amplifier and speakers and can cause a fire. Consult an approved service personnel if damage occurs or if there is a sudden apparent change in performance. • Do the procedures included in these instructions when you attach the speakers. 5 RQT0B23