Panasonic SC-PM700 Owners Manual - Page 5

ENGLISH Supplied accessories Check and identify the supplied accessories.  1 AC power supply cord (K2CB2YY00065)  1 FM indoor antenna (RSAX0002) Making the connections Connect the AC power supply cord only after all the other connections have been made.  1 Remote control (N2QAYB000984) Note: • Product numbers correct as of March 2023. These may be subject to change. • The included Canadian French label sheet corresponds to the English printing on the main unit and remote control. 32 1 Placement of speakers The left and right speakers are the same. 1 Connect the FM indoor antenna. Put the antenna where reception is best. Adhesive tape (not supplied) 2 Connect the speakers. Use only the supplied speakers. Red You can cause damage to the system and decrease the sound quality if you use other speakers. Note: • Keep your speakers at least 10 mm (1332") away from the system for proper ventilation. • Put the speakers on a flat safe surface. • These speakers do not have magnetic shielding. Do not put them near TVs, PCs or other equipment easily influenced by magnetism. • When you play at high levels for a long period, it can cause damage to the speakers and decrease the life of the speakers. • Decrease the volume in these conditions to prevent damage: - When the sound is distorted. - When you adjust the sound quality. Black Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. 3 Connect the AC power supply cord. Do not use an AC power supply cord from other equipment. CAUTION! • Use the speakers only with the recommended system. If not, you can cause damage to the amplifier and speakers and can cause a fire. Consult an approved service personnel if damage occurs or if there is a sudden apparent change in performance. • Do not modify the speaker or speaker wires as this can cause damage to the system. To household AC outlet Conserving power The system consumes a small amount of power (~"Specifications") when it is in standby mode. TQBM0873 Disconnect the power supply if you do not use the system. Some settings will be lost after you disconnect the system. You have to set them again. 5