Panasonic SC-UX100 Owners Manual - Page 12
External equipment, Others
View all Panasonic SC-UX100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
External equipment You can connect a VCR, DVD player etc., and listen to the audio through this system. Preparation • Disconnect the AC power supply cord. • Turn off all equipment and read the appropriate operating instructions. DVD player (not supplied) Rear panel of this main unit Audio cable (not supplied) 1 Connect the external equipment. 2 Press [RADIO/AUX] to select "AUX". 3 Play the external equipment. To adjust the input level 1 Press [PLAY MENU] to select "INPUT LEVEL". 2 Press [R, T] to select "NORMAL" or "HIGH" and then press [OK]. Note: • Select "NORMAL" if the sound is distorted during "HIGH" input level. • Components and cables are sold separately. • If you want to connect equipment other than those described, refer to the audio dealer. • Sound distortion can occur when you use an adapter. Others Illumination You can turn on or turn off the illumination on the system. 1 Press [SETUP] to select "ILLUMINATION". 2 Press [R, T] to select "ON" and then press [OK]. To cancel, select "OFF". Auto off This system automatically turns off when you do not use it for approximately 20 minutes. 1 Press [SETUP] to select "AUTO OFF". 2 Press [R, T] to select "ON" and then press [OK]. To cancel, select "OFF". Note: This function does not work when you are in radio source or when a Bluetooth® device is connected. Bluetooth® standby This function automatically turns on the system when you establish a Bluetooth® connection from a paired device. 1 Press [SETUP] to select "BLUETOOTH STANDBY". 2 Press [R, T] to select "ON" and then press [OK]. To cancel, select "OFF". Note: Some devices may take longer to respond. If you are connected to a Bluetooth® device before turning off the system, wait for a minimum of 5 seconds before connecting to this system from your Bluetooth® device again. Software version You can check the software version of the system. 1 Press [SETUP] to select "SW VER." and then press [OK]. The software version is shown. 2 Press [OK] again to exit. TQBJ0973 12