Panasonic SC-ZT1 Home Theater Audio System - Page 14
Checking the speaker setting, Make sure that the display of main unit matches speaker locations.
UPC - 037988983643
View all Panasonic SC-ZT1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Connection Speaker setting When the speakers are detected, the Wireless Link display lights up on the main unit's display. W (Blinks during detecting operation.) While the wireless speakers operate normally, the Wireless Link display lights, but when radio waves are interrupted (When speakers are in standby condition, etc.), it blinks. Display Wireless Link display • When you turn the main unit off with the speakers on, the speakers automatically enter standby (Wireless link standby). The color of [WIRELESS LINK] indicator turns to red. • To reduce more of the power consumption of speakers in standby, turn the speakers off. The speakers enter standby (In standby condition). Wireless link standby: approx. 0.8 W (for 1 speaker) In standby condition: approx. 0.1 W (for 1 speaker) Checking the speaker setting 1. Turn the main unit on. 2. Press [TEST] on the remote control to output the test signal. Press • To adjust the speaker volume, press [VOL +, -]. 3. Make sure that the display of main unit matches speaker locations. The test signal is output from one speaker at a time for about 2 seconds in the order shown below. "TEST L " → "TEST R " → "TEST RS " ✽ → "TEST LS " ✽ Confirm the correct setting locations in the following chart. Display Speaker outputting the test signal TEST L Front left TEST R TEST RS ✽ TEST LS ✽ Front right Surround right (right back) Surround left (left back) ✽ This is not displayed when using the front speakers only. Note If the speakers are not properly set, do either of the following. • Move the speakers according to the unit's display. • Perform steps 3 and 4 of "Setting the speakers" (➜ page 13). When using only front speakers, perform steps 4 and 5 of "Setting front speakers only" (➜ page 15). 4. Press [TEST] on the remote control to stop the test signal. If the speaker is repaired or replaced Perform the above "Checking the speaker setting" to confirm that the speaker properly operates. Do the following operations if the sound is not produced normally. 1. Press and hold [INPUT SELECTOR] on the main unit about 3 seconds until "4CH SEARCH " is displayed. 2. Perform steps 2 to 4 of "Setting the speakers" (➜ page 13). Speaker setting 14 RQT9471