Panasonic SC-ZT1 Home Theater Audio System - Page 15

Setting front speakers only Make this setting after the speaker setting on page 13 is complete. Preparations • Make sure that all equipment has been turned off. (When the VIERA Link "HDAVI Control" compatible Panasonic TV (VIERA) and Blu-ray Disc player/DVD recorder (DIGA) are connected, do not turn on TV (VIERA) and Blu-ray Disc player/DVD recorder (DIGA) until the setting is complete.) • Turn the main unit on. (➜ page 13) • Turn 2 speakers on. (➜ page 13) • Prepare the remote control. (➜ page 7) 1. Set "2CH " at the setting operation of "Changing the number of speakers to 2" below. 2. Turn the main unit off once. 3. Turn the main unit on again. 4. Press and hold [CH] on the remote control for about 3 seconds until "2 SPKR SET " is displayed on the main unit's display. • Always aim the remote control at the main unit for operation. 5. Press the remote control button corresponding to the speaker outputting the confirmation sound. Front speaker (left) Front speaker (right) When the sound is output from the front speaker (left), press [GAME]. When the sound is output from the front speaker GAME MUTE (right), press [MUTE]. Connection Speaker setting • Sound is output from either of the speakers. • When you press the button corresponding to the confirmation sound of speaker, another speaker outputs confirmation sound. Press the corresponding button in the same way and complete settings for all 2 speakers. • When "COMPLETE " disappears on the main unit's display, the speaker setting is complete. Note • Check if the speakers are properly set after setting the speakers. (➜ page 14) • If the speakers are set incorrectly in step 5, turn the main unit off then on again and perform steps 4 and 5. • If [WIRELESS LINK] indicator does not change from red to green, see page 27 of "Troubleshooting guide". Changing the number of speakers to 2 „ To return to the previous display/To cancel during setting operation: Press [ RETURN]. 1. Press and hold [-SETUP, OFF] for about 2 seconds. The setting items are displayed. (➜ page 21) 2. Press [w][q] to select "SPEAKERS " and press [OK]. 3. Press [e][r] to select "2CH " and press [OK]. 2CH : When only front speakers are installed 4CH : When surround speakers are additionally installed (factory setting) • When changing the number of speakers to 4, select "4CH " and press [OK]. 4. Press [e][r] to select "YES " and press [OK]. • To cancel, select "NO ". 5. Press [ RETURN] several times to select "EXIT " and press [OK] to finish the setting. Note When you select "EXIT " and press [OK], the setting mode finishes in step 2. 15 RQT9471