Panasonic SCHC35 SCHC35 User Guide - Page 15
Others
View all Panasonic SCHC35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH Disconnecting a Bluetooth® device 1 Press [ , iPod] repeatedly to select "BLUETOOTH". 2 Press [ MENU] to display "DISCONNECT?" and then press [OK]. A confirmation message is displayed. 3 Press [2, 1] to select "YES" and then press [OK]. ≥ The connection can also be stopped when you disable Bluetooth® transmission on the connected Bluetooth® device. Advanced functions Preparation Press [ , iPod] repeatedly to select "BLUETOOTH". ≥ These functions are unavailable if a device is connected. Disconnect the Bluetooth® devices to display these functions. ∫ To register more devices 1 Press [ MENU] repeatedly to select "NEW DEV." and then press [OK]. ≥ The unit enters pairing mode and "PAIRING" starts blinking on the display. 2 While this unit is in pairing mode, access the Bluetooth® menu of the Bluetooth® device and execute a Bluetooth® search to find this unit (SC-HC55). ≥ If prompted for the passkey, enter "0000". ∫ To select communication quality 1 Press [ MENU] repeatedly to select "LINK MODE". 2 Press [2, 1] to select the following modes and then press [OK]. MODE 1: Connection with emphasis on communication stability MODE 2: Connection with high bit rate for good audio quality (Communication might easily be disconnected in this mode, select "MODE 1" if this occurs). Others Changing the main unit and remote control mode Other Panasonic audio/video equipment may start functioning when you operate the unit using the supplied remote control. You can operate this unit in another mode by setting the remote control operating mode to "REMOTE 2". The main unit and remote control must be set to the same mode. 1 Press [EXT-IN, RADIO] to select "AUX". 2 Press and hold [RADIO/EXT-IN] on the main unit and [2] on the remote control until the main unit's display shows "REMOTE 2". 3 Press and hold [OK] and [2] on the remote control for at least 4 seconds. To change the mode back to "REMOTE 1", repeat the steps above by replacing [2] with [1]. Memory reset (Initialization) When the following situations occur, reset the memory: ≥ There is no response when buttons are pressed. ≥ You want to clear and reset the memory contents. ∫ To reset memory 1 Disconnect the AC power supply cord. (Wait for at least 3 minutes before proceeding to step 2.) 2 While pressing and holding down [POWER, Í/ I] on the main unit, reconnect the AC power supply cord. "--------" appears on the display. 3 Release [POWER, Í/I]. All the settings are returned to the factory preset. You will need to reset the memory items. ∫ To select Auto Link mode 1 Press [ MENU] repeatedly to select "AUTO LINK". 2 Press [2, 1] to select the following modes and then press [OK]. ON: OFF This unit will automatically select "BLUETOOTH" when a Bluetooth® device is connected. ≥ When "LINKING" is displayed, pressing [ MENU] is invalid. ≥ Auto Link works only if your device supports A2DP. ≥ The communication quality settings also depend on the settings on the connected device. If the communication quality of the connected device is set for stable communication, the quality of the audio will remain low even if this unit is set to "MODE 2". RQTX1260 15