Panasonic SCNA30 SCNA10 User Guide - Page 14

Receiving a call hands-free If receiving a call on the mobile phone connected to this unit with Bluetooth®, you can make a hands-free call through this unit. Preparation Connect this unit and the mobile phone with Bluetooth®. ∫ Receiving a call Press [ ] when this unit rings. • When receiving the call, the Bluetooth® indicator (blue) on the unit blinks. • Talk into the microphone (> 6, 7) on this unit. ∫ Ending the call Press [ ]. Note • Adjust the volume during a call with volume knob on this unit. • When the mobile phone and the unit are connected with Bluetooth®, even if you receive a call and have a conversation on the mobile phone, the unit may also output the incoming voice. To switch from a hands-free call using the unit to a call using only the mobile phone, operate the mobile phone. • If a call is received during audio playback using a Bluetooth® connection, the sound will automatically switch to the ringtone. If a call is received while the AUX IN jack is in use, the sound will switch to the ringtone of the mobile phone connected with Bluetooth®. • If you touch other devices to the NFC touch area of this unit when receiving a call, Bluetooth® connection will not switch. • To mute the ringtone, turn the volume knob of the unit to [- VOL] until no sound can be heard. • Some apps for the mobile phone may not be available for hands-free. • In a place with poor mobile phone reception, it may be harder to have a conversation. Use the mobile phone in a place with good reception. • In a place where voices echo considerably, such as an area near a wall, it may be harder to have a conversation. Before using the unit, move it away from the wall or lower its volume. To return to the factory preset state Perform the following when you want to delete pairing device information, etc. Preparation Turn off the unit, and remove the AC adaptor. Press and hold [Í/I] for 10 seconds until Bluetooth® indicator (blue) and LP Mode indicator (green) blink twice. The pairing device information will be deleted by the reset, so it will be necessary to perform pairing again. Delete the pairing information for this unit from the Bluetooth® device, then perform the pairing operation again. (> 10, 11) 14 VQT5C36