Panasonic SCNE1 SCNE1 User Guide - Page 8
Sound adjustment, Other, To cancel this function
View all Panasonic SCNE1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Sound adjustment The following sound effects can be added to the audio output. 1 Press [SOUND] repeatedly to select the effect. 2 Press [3, 4] to select the setting and then press [OK]. Direct-Vocal Surround (D.SURROUND) "LEVEL 1", "LEVEL 2" or "OFF". ≥ The factory preset is "OFF". Preset EQ (PRESET EQ) Bass (BASS) or Treble (TREBLE) "HEAVY" (heavy), "SOFT" (soft), "CLEAR" (clear), "VOCAL" (vocal) or "FLAT" (flat/off). ≥ The factory preset is "HEAVY". Adjust the level (j4 to i4). Dynamic Bass* (D.BASS) "ON D.BASS" or "OFF D.BASS". ≥ The factory preset is "ON D.BASS". * This function can also be selected with the [D.BASS] button on the unit. ≥ You may experience a reduction in sound quality when these effects are used with some sources. If this occurs, turn the sound effects off. Others Sleep timer The sleep timer can turn the unit off after a set time. 1 Press [SETUP] to select "SLEEP". 2 Press [3, 4] to set the time (in minutes) and then press [OK]. "SLEEP 30" ,. "SLEEP 60" ,. "SLEEP 90" ,. "SLEEP 120" OFF" (Cancel J ≥ The remaining time is indicated on the unit's display except when other operations are performed. Display brightness The brightness of this unit's display can be changed. 1 Press [SETUP] repeatedly to select "DIMMER". 2 Press [3, 4] to select "ON" and then press [OK]. ≥ To cancel the dimmer, select "OFF" in step 2. Automatic standby As a factory preset, this unit will always turn off automatically if there is no sound output and no operation for approx. 30 minutes. To cancel this function 1 Press [SETUP] repeatedly to select "AUTO OFF". 2 Press [3, 4] to select "OFF" and then press [OK]. ≥ To turn automatic standby on, select "ON" in step 2. Changing the unit and remote control code When other Panasonic equipment responds to the supplied remote control, change the remote control code. 1 Press [ , AUX] to select "AUX". 2 While pressing and holding [ / AUX] on the unit, press and hold [SOUND] on the remote control until the unit's display shows "REMOTE 2". 3 Press and hold [OK] and [SOUND] on the remote control for at least 4 seconds. ≥ To change the mode back to "REMOTE 1", repeat the steps above but replace the button pressed on the remote control from [SOUND] to [ , AUX]. 8 VQT4T91