Panasonic SDYD250 SDYD250 User Guide - Page 15
Display Indications For Abnormal Conditions - bread maker
UPC - 100000004746
View all Panasonic SDYD250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Display indications for abnormal conditions Condition TEMP TEMP appears on display. ALERT is on display. ALERT is on display. Reason/Cause The unit is hot (above 40ßC/105ßF). This may occur during repetitive use. You must allow the unit to cool down before reusing. There has been a 10-minute or less power cut. (The power plug has been inadvertently pulled out or the breaker has activated.) Or there has been a slight change in the power supplied to the machine. There has been more than 10 minutes of power loss due to power failure, unplugging of the power cord, or a malfunctioning of household fuse or breaker. How to reset/restart Leave the unit as it is. When the unit has cooled to below 105ßF/40ßC, TEMP will disappear from the display window and the red indicating light will go out. This indicates that the unit is now ready to use. If the interruption in the power supply is momentary, the operation will not be affected. If the power is restored within 10 minutes, the bread maker will operate again. However, the bread may not turn out well. Remove the dough and start again using all new ingredients. Not baked at all, although the operation appears to have proceeded. Motor protection device has activated. This only happens when the unit is overloaded and an excessive force is applied to the motor. After about 30 minutes, the motor automatically starts running again. Check to see if the kneader mounting shaft can rotate. Yes No Make sure you did not use too much or too hard/heavy ingredients, then start again using all new ingredients. Service will be required. Motor protection device If the unit is overloaded and an excessive force is applied to the motor, the protection device will stop the motor. After approximately 30 minutes, the motor will automatically start running again. It is recommended to restart with fresh ingredients. Remedy 1 If the kneading blade is restricted by hard dough, take out the dough. The unit will restart 30 minutes later. Remedy 2 Check to see if the kneader mounting shaft of the bread pan can rotate. If it can rotate, restart the bread maker after 30 minutes. If it cannot rotate, service will be required. - 14 -