Panasonic SL-1200GR2 Owners Manual Multi-lingual - Page 20

Adjustment (continued) Armlift height Make an adjustment according to your cartridge if necessary. Preparation  Put a record on the turntable.  Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp.  Lift the cue lever and move the tone arm over the record. 1 Check the armlift height (distance between the stylus tip and record surface). If adjustment is needed, go to step 2 .  The armlift height is factory-adjusted to 8 to 13 mm (5/16 to 33/64 "). 8 to 13 mm (5/16 to 33/64 ") 2 Return the tone arm to the arm rest, clamp it with the arm clamp and while pressing the armlift down with your finger, turn the screw to adjust the height.  Turning the screw clockwise lowers the armlift.  Turning the screw anti-clockwise raises the armlift. Armlift   20 (20) English Armlift screw Arm clamp Adjusting the turntable startup/ brake speed BRAKE button ([1] - [5]) S (Slow) .... Reduce the brake speed(-1) F (Fast)...... Increase the brake speed(+1) BSRAKEF Confirmation lamp Torque button ([1] - [3]) L (Low) ... Reduce the torque(-1) H (High).. Increase the torque(+1) L H TORQUE  Press the center of the button lightly. Startup speed You can select from three time options for the turntable to reach constant speed after [START- STOP] is pressed. Press the H button to increase the torque (the power required to rotate) and shorten the time to stabilize rotation. (The factory setting is [3]: highest.) The confirmation lamp blinks the specified number Example) When the setting is [3]. of times according to the current setting when you press the H or L torque button. L H TORQUE (Blinks three times) To change the setting, press the H or L torque button while the lamp is lit for two seconds. L H (Lit two seconds) TORQUE After you press the torque button, the confirmation lamp blinks the specified number of times showing the new setting, stays lit for two seconds Example) When the setting is [1]. and then goes off. (Blinks one time) (Lit two seconds) (Off/end) Brake speed You can select from five time options for the turntable to stop after [START-STOP] is pressed. (You can change the brake power.) (The factory setting is [5]: fastest.) The confirmation lamp blinks the specified number of times according to the current setting when you press the F or S brake button. Example) When the setting is [5]. BRAKE S F (Blinks five times) To change the setting, press the F or S brake button while the lamp is lit for two seconds. (Lit two seconds) BRAKE S F After you press the brake button, the confirmation lamp blinks the specified number of times showing the new setting, stays lit for two seconds and then goes off. Example) When the setting is [3]. (Blinks three times) (Lit two seconds) (Off/end)