Panasonic SU-C550 Operating Instructions - Page 21
wireless network settings., Allow the iPhone to share
View all Panasonic SU-C550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Using the WPS PIN code "WPS PIN" If your wireless router supports WPS, you can set up a connection by entering the WPS PIN code. • For details on how to enter the PIN code, refer to the operating instructions of the wireless router. 1 Press [ ], [ ] on the remote control to select "WPS PIN" and then press [OK]. • The PIN code is displayed. Complete step 2 within 2 minutes. 2 Enter the PIN code into the wireless router from PC, etc. • "Linking" is displayed. • When the connection is established, "Success" is displayed. - "Fail" may be displayed if the connection was not complete. Try this method again from [SETUP] menu. If "Fail" is still displayed, try other methods ( 19). 3 Press [OK] on the remote control to exit the setting. • " " is displayed. Note • Depending on a router, other connected devices may temporarily lose their connection. • For details, refer to the operating instructions of the wireless router. Using iPhone/iPad/iPod "With iPod" With this method you will share the wireless network settings of your iPod/iPhone/iPad with this system. • Supported device: iPhone/iPad/iPod touch (iOS version 5.0 or later) • The following explanations are based on an iPhone. • Make sure your iPhone is connected to your home wireless network beforehand. USB cable (supplied with iPhone/iPad/iPod) 1 Connect the iPhone to this unit with the USB cable. • Use the USB cable supplied with iPhone/ iPad/iPod. • Unlock your iPhone before connecting. 2 Press [ ], [ ] on the remote control to select "With iPod" and then press [OK]. • "Connecting Wi-Fi" is displayed. 3 Allow the iPhone to share the wireless network settings. • When the connection is established, "Success" is displayed. - "Fail" may be displayed if the connection was not complete. Try this method again from [SETUP] menu. If "Fail" is still displayed, try other methods ( 19). 4 Press [OK] on the remote control to exit the setting. • " " is displayed. Connections 21