Panasonic SV-P10U Printer - Page 24
Before Requesting Service Cont., The full picture is printed with part of the image
UPC - 037988310173
View all Panasonic SV-P10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Before Requesting Service (Cont.) 6: Battery runs down quickly. 6-1: Are you using the Battery in an extremely cold place? In cold places, the operating time of the Battery becomes shorter. 6-2: Has the Battery worn out? If the operating time is still too short even after the Battery is fully charged, the Battery has worn out. 7: Paper is discharged from the back of the printer with no printing. 7: If any error has occurred inside of the printer, paper is discharged with no printing. 8: Paper is discharged from the front of the printer with no printing. 8: There is no ink in the Ink Cassette. Replace the Ink Cassette with a new one. 9: The [ACCESS] Lamp stay lit for a long time. 9: The high resolution image takes long time to read. The following are approximate reading time per resolution. 640t480 (VGA) :About 4 seconds 1280t960 (1.3 million pixels) : About 12 seconds 1600t1200 (2 million pixels) : About 20 seconds 2240t1680 (4 million pixels) : About 40 seconds 10: The date specified in DPOF is printed within an image. 10: If your device can specify the date information in DPOF, such the date information may be printed within an image. 11: The printer wants to restart printing from the initial page during printing. 11: Press the Clear Button[ ] for about 2 seconds. 12: While the printer is ready to start, paper has not been fed into the printer. 12: Remove the paper and confirm that the print lamp is on. Then re-feed the paper fully into the printer. 13: The printer wants printing only the selected images. 13: Use the printer applicable for DPOF configuration and implement DPOF configuration through its software. (This printer can use the information formatted with DPOF configuration, but cannot implement DPOF configuration itself). 14: The full picture is printed with part of the image is cut off. 14: If the print aspect ratio of the image is about 4:3, its edge is automatically trimmed because this printer intends to print using the maximum area available to print. 15: Printing is tried, but the Printer remains unoperated. 15-1:When the ambient temperature or that within the SD Mobile Printer is low, the SD Mobile Printer feeds the paper and stops operating to warm itself for a while. Wait for one or two minutes until the temperature rises. 15-2:If you insert a sheet of paper before the Access Lamp [ACCESS] turns OFF and the Print Lamp [PRINT] turns ON, printing does not occur. Re-insert the paper. 24 16: When you print an image from the personal computer, the image size does not match with the paper. 16: To print an image matching with the paper, convert the image to one consisting of 320t 256 dots with the resolution 203 dpi. (Some applications may vary the aspect ratio.) Some applications may not allow the size or resolution to be set. 17: If two SD Mobile Printers are connected to the personal computer, printing does not occur. 17: Two or more SD Mobile Printers connected to one personal computer do not operate normally. Do not connect two or more SD Mobile Printers. 18: The Power Lamp starts flashing while the SD Mobile Printer is printing. 18: The flashing Power Lamp indicates that the number of printable copies is reduced. (A few more copies can be printed.) When the Power Lamp flashes more frequently, printing will stop. (If a sheet of paper is being printed, printing will stop after it is completed to be printed.)