Panasonic TGA650 Installation Manual - Page 2
Hancset, Registering, Registered
View all Panasonic TGA650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Charging the battery Place the handset on the charger and charge for 6 hours before initial use. • The unit beeps once, the CHARGE indicator lights and "Charging" is displayed. • When the battery is fully charged, "Charge completed" is displayed if there are no new calls in the Caller List. • Recharge the battery when: -"Recharge battery" is displayed on the handset, - "4- 1 flashes, or - the handset beeps intermittently while it is in use. Charge Contact P02 CHARGE Indicator • If the battery has been discharged, the handset will display "Charge for 6 HRS" and "f1 when you place the handset on the charger. The handset will not work unless the battery is charged. Continue charging. Handset battery information After your Panasonic battery is fully charged, you can expect the following performance: Operation Operating time While in use (TALK) Up to 5 hours While not in use (Standby) Up to 11 days While using the Clarity Booster feature Up to 3 hours • Clean the charge contacts of the handset and the charger with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or high humidity. Otherwise the battery may not charge properly. Belt Clip You can hang the handset on your belt or pocket using the included belt clip. To attach the belt clip To remove the belt clip While pressing the top of the clip (a), pull the right edge in the direction of the arrow (s). A Registration This cordless handset, KX-TGA650, must be registered to a KX-TG6500/KX-TG6502 base unit. The handset will be assigned the extension number at registration. Only one handset can be registered at a time. Charge the battery fully. Make sure the base unit and the other handsets are not being used. Have both the handset and base unit nearby during registration. [LOCATOR/INTERCOM/ TRANSFER] S LOCATOR base und 3 sec. pre, OK3 CHARGE Indicator \..C) 0 2 era To operate " O K „, press the right soft key. 0 The handset display shows the instructions as shown on the right. Press LOCATOR on base unit for 3 sec. Then press OK, OK 1 Base unit: Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds. • The CHARGE indicator flashes. After the CHARGE indicator starts flashing, the rest of the procedure must be completed within 1 minute. 2 Handset: (1) Press the soft key ( O K ). IMO Hancset Registering (2) Wait until a long beep sounds and the display shows the new extension number. • Registration is complete. Ex. Extension number 2 [2] Hancset [2] Registered • The registered number " [1]" to " [4]" is shown on the top right of the display. • You can stop registration by pressing [OFF] on the handset and pressing [LOCATOR/ INTERCOM/TRANSFER] on the base unit. • Do not try to register KX-TGA650 to a KX-TG5200/KX-TG5202/KX-TG5210/KX-TG5212/ KX-TG5230/KX-TG5240/KX-TG5243/KX-FPG391 base unit. If you do, "Wrong handset Refer to manual" will be displayed. The correct base unit for this handset KX-TGA650 is KX-TG6500/KX-TG6502. To cancel the handset registration, please see your base unit Operating Instructions. - 2 - For assistance, please call: 1-800-211-PANA(7262) -3-