Panasonic TH-50PD12UK 42" Plasma Tv - Page 10
SERIAL Terminals connection - hd
UPC - 037988242702
View all Panasonic TH-50PD12UK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Connections SERIAL Terminals connection The SERIAL terminal is used when the Plasma Display is controlled by a computer. COMPUTER (Male) 12345 6789 RS-232C Straight cable (Female) Pin layout for SERIAL Terminal D-sub 9p Notes: • Use the RS-232C straight cable to connect the computer to the Plasma Display. • The computer shown is for example purposes only. • Additional equipment and cables shown are not supplied with this set. The SERIAL terminal conforms to the RS-232C interface specification, so that the Plasma Display can be controlled by a computer which is connected to this terminal. The computer will require software which allows the sending and receiving of control data which satisfies the conditions given below. Use a computer application such as programming language software. Refer to the documentation for the computer application for details. Communication parameters Signal level Synchronization method Baud rate Parity Character length Stop bit Flow control RS-232C compliant Asynchronous 9600 bps None 8 bits 1 bit - Basic format for control data The transmission of control data from the computer starts with a STX signal, followed by the command, the parameters, and lastly an ETX signal in that order. If there are no parameters, then the parameter signal does not need to be sent. STX C1 C2 C3 : P1 P2 P3 P4 P5 ETX Start (02h) Colon Parameter(s) 3-character (1 - 5 bytes) command (3 bytes) End (03h) Notes: • If multiple commands are transmitted, be sure to wait for the response for the first command to come from this unit before sending the next command. • If an incorrect command is sent by mistake, this unit will send an "ER401" command back to the computer. Signal names for D-sub 9P connector Pin No. 2 Details R X D 3 T X D 5 GND 4 • 6 7 8 Non use (Shorted in this set) 1 • 9 NC These signal names are those of computer specifications. Command Command PON POF AVL AMT IMS Parameter None None ** 0 1 None SL1 SL2 SL3 PC1 Control details Power ON Power OFF Volume 00 - 63 Audio MUTE OFF Audio MUTE ON Input select (toggle) INPUT1 (VIDEO) INPUT2 (S-VIDEO) INPUT3 (COMPONENT) INPUT4 (PC) DAM None ZOOM FULL JUST NORM SJST SNOM SFUL ZOM2 Screen mode select (toggle) ZOOM (For Video/SD/PC signal) FULL JUST (For Video/SD signal) 4:3 (For Video/SD/PC signal) JUST (For HD signal) 4:3 (For HD signal) H-FILL (For HD signal) ZOOM (For HD signal) With the power off, this display responds to PON command only. 10