Panasonic TH42PH10UK 42" Plasma Television - Page 11
SERIAL Terminals connection - th boards
UPC - 037988241576
View all Panasonic TH42PH10UK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
SERIAL Terminals connection Connections The SERIAL terminal is used when the Plasma Display is controlled by a computer. COMPUTER (Example: TH-42PH10UK) RS-232C Straight cable SERIAL TH-37PH10UK 9876 54321 TH-42PH10UK, TH-50PH10UK, TH-58PH10UK 12345 6789 Notes: D-sub 9p • Use the RS-232C cable to connect the computer to the Plasma Display. • The computer shown is for example purposes only. • Additional equipment and cables shown are not supplied with this set. Pin layout for SERIAL Terminal The SERIAL terminal conforms to the RS-232C interface specification, so that the Plasma Display can be controlled by a computer which is connected to this terminal. The computer will require software which allows the sending and receiving of control data which satisfies the conditions given below. Use a computer application such as programming language software. Refer to the documentation for the computer application for details. Communication parameters Signal level Synchronization method Baud rate Parity Character length Stop bit Flow control RS-232C compliant Asynchronous 9600 bps None 8 bits 1 bit - Basic format for control data The transmission of control data from the computer starts with a STX signal, followed by the command, the parameters, and lastly an ETX signal in that order. If there are no parameters, then the parameter signal does not need to be sent. STX C1 C2 C3 : P1 P2 P3 P4 P5 ETX Start (02h) Colon Parameter(s) 3-character (1 - 5 bytes) command (3 bytes) End (03h) Notes: • If multiple commands are transmitted, be sure to wait for the response for the first command to come from this unit before sending the next command. • If an incorrect command is sent by mistake, this unit will send an "ER401" command back to the computer. • SL1A, SL1B, SL2A and SL2B of Command IMS are available only when a dual input terminal board is attached. • With the power off, this display responds to PON command only. RS-232C Conversion cable D-sub 9-pin female 2 Details R X D 3 T X D 5 GND 4 • 6 7 8 Non use Shorted 1 • 9 NC Command Command PON POF AVL Parameter None None ** Control details Power ON Power OFF Volume 00 - 63 AMT IMS 0 1 None SL1 SL2 SL3 PC1 SL1A SL1B SL2A SL2B Audio MUTE OFF Audio MUTE ON Input select (toggle) Slot1 input Slot2 input Slot3 input∗ PC input Slot1 input (INPUT1A) Slot1 input (INPUT1B) Slot2 input (INPUT2A) Slot2 input (INPUT2B) DAM None NORM ZOOM FULL JUST SELF Screen mode select (toggle) NORMAL (4 : 3) ZOOM FULL JUST Panasonic AUTO ∗SLOT3 cannot be selected on TH-37PH10UK. 11