Panasonic TH50PHD7UX TH37PWD7UX User Guide - Page 9
Connections
View all Panasonic TH50PHD7UX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Connections When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker's Installation Manual for details on speaker installation. Make sure to use the supplied ferrite core speaker cables to connect speakers. Other types of speaker wires are not suitable. 1 (Example: TH-42PWD7UX) Speakers (Optional accessories) Remove the tubes from the ends of the speaker wires. 2 SPEAKER Terminal (R) 31 2 SPEAKER Terminal (L) AC cord connection (see page 12) - AC cord fixing 1. Open the clamper. 2. Insert the AC cord and close the clamper securely. 3. Slide up the clamper and fix the AC cord plug securely. When loosen the clamper: Clamper AC cord Note: The power plug in the illustration may not be the type fitted to your set. - Cable fixing bands Secure any excess cables with bands as required. Pass the attached cable fixing band through the clip as shown in the figure. To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure. While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band. To tighten: To loosen: Push the catch Pull 1 2 Pull Optional Terminal Board insert Slots (covered) SLOT1 SLOT2 AUDIO PC IN SERIAL SLOT3 From EXTERNAL monitor terminal on Computer (see page 10) From SERIAL Terminal on Computer (see page 11) 9