Panasonic TXP50GT30B Operating Instructions - Page 117

Message External (USB-HDD) Recording Due to Start Faulty dish Feature not available. Feature not available. Press OK to view how it works. ∗∗∗ Found new software version . Press OK to start update (may take over 40 mins) or press EXIT to ignore and you can update when TV is in standby Invalid operation - Please check settings and connections. Invalid system time. Please exit ! Invalid system time, Timer Programming will not work. Please press TV button on remote control and check time display on Banner Max. number of timers already set ! New channels found! Press OK to update channel list. Press EXIT to ignore. No channel found. Please check aerial or local signal availability. Press OK to start Auto Setup. No module inserted No recording Already recording No recording Check media No recording - Playing No recording - Unknown reason No service No signal Overcurrent error on USB device occurred. Please remove the USB device, and switch off the TV by mains power switch. PIN incorrect! Please check settings and connections on HDMI devices. Please enter a frequency between 10700 and 12750 MHz. Please check settings and connections on HDMI devices. Please wait. Recording this channel now Meaning / Action • This message will appear 2 minutes before timer programming event for external (USB HDD) recording due to start. • The satellite cable might be short-circuited or there might be connection problems of the cable. Check the cable and connection and then turn the TV Off with the Mains power On / Off switch, and turn it On again. • If the message still persists, it may be necessary to consult a dish installer for checking the dish and cable. • It is not possible to record from COMPONENT or HDMI. Connect the recorder to the • TV using a fully wired SCART cable for recording from the TV tuner. Confirm Q-Link or VIERA Link settings (p. 95 - 98) • The selected feature on VIERA TOOLS is not available. Press the OK button to view the demonstration to explain how to use it. • There is a new software available. • Check the Q-Link or VIERA Link connection and setting (p. 95 - 98) • Cannot get the time information and cannot edit Timer Programming screen. Check the connection of the RF cable. • Cannot get the time information. If there is no time displayed on the Information banner, check the connection of the RF cable. • The maximum number of timer programming events is 15. • There may be new channels available. • This message will appear each time a change is made by the broadcasters. This message can be deactivated by setting [New Channel Message] to Off in [DVB Tuning Menu]. Selecting OK will perform [Update Channel List]. • Follow the on screen instructions. • Please also refer to p. 114. • If channels are still not found, consult your local Panasonic dealer. • Check the CI module is inserted completely (p. 64). • The equipment may already be recording. On screen messages • The tape or disc may be "write protected", full, missing or damaged. • The equipment may be playing the tape or disc. • The recording may not be performed. Check the equipment. • The broadcaster has stopped the service. Check the channel in the TV Guide. (p. 22) • The TV cannot detect the signal. Check the connection of the RF cable. • The connected USB device might cause overcurrent error. Follow the on screen • instructions. Check if foreign objects are inside the USB port. • The PIN number you entered is wrong. • Communication error in VIERA Link function (p. 98). • The frequency you entered is out of range. Consult the received satellite broadcasting company. (p. 56) • Communication error in VIERA Link function (p. 98). • A function is in progress. • The recorder is recording the programme from its own tuner. You can turn the TV off and leave the equipment recording in the normal way. 117