Panasonic TY-SP42P8W-K Installation Instructions - Page 3
Notes on use - speaker
![]() |
UPC - 037988158928
View all Panasonic TY-SP42P8W-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
English 3. Attach the speakers to the Plasma Display. 4. Secure the speakers in place. Bracket mounting Slot screw Hook Rear of Plasma Display • Insert the hooks and pin on the top and bottom mounting brackets simultaneously into the slots at the rear of the plasma display, and then lower the speaker into place. • Attach the left speaker in the same way. 5. Connect the speaker cables. Rear of Plasma Display • Secure the top and bottom mounting brackets by tightening the bracket mounting screws. • Secure the left speaker in the same way. • To change the amount of clearance between the speakers and the display, loosen the bracket mounting screws, make adjustments as desired, and then tighten the screws. • Tighten the bracket mounting screws securely so that the speakers are not loose and do not rattle. Preparing the ends of the speaker cables Remove while twisting 1. Press down on the lever. 2. Insert the cable. 3. Release the lever. 1. Push down the lever. 2. Insert the cable. 3. Return the lever to its normal position. • After preparing the ends of the speaker cables, connect them as shown. • The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cables to the wrong sides. • When connecting the speaker cable, make sure that the core of the cord does not short. Notes on use 1. If connecting to an external amplifier that exceeds the rated input for the speakers, keep the amplifier volume suitably low to protect the speakers from damage. If any problems occur with speaker operation, disconnect the mains lead of the amplifier and consult a qualified service technician. 2. Do not place the speakers in the following places: • Areas that are exposed to direct sunlight • Near heaters or other heat sources • Areas subject to high humidity 3. This set is equipped with magnetic resistant speakers. However be careful not to place it near a CRT as it may cause color patches. 4. To clean the speakers, wipe them with a soft cloth. If they are extremely dirty, wipe them with a cloth that has been soaked in a small amount of household detergent, and then wipe them dry with a separate cloth. • Do not use solvents such as alcohol or thinner. • If using chemically-treated cloths, follow the instructions supplied with the cloth packaging. 3
![](/manual_guide/products/panasonic-tysp42p8wk-installation-instructions-0716fee/3.png)