Panasonic U1 Electronic Board - Page 19

Using Storing images on an SD memory card 1 Set the power switch to on ( I ). 2 Open the SD memory card cover and insert the SD memory card into the SD memory card slot until it is locked. Then close the SD memory card cover. Scanning 3 Press the Mode Key scanning mode. to select the 4 Press the Start/Stop Key. • The unit starts scanning. • The scanning status is shown on the display. • When scanning has finished, a preview of the scanned image is shown on the display. • The SD memory card icon is shown on the display. The display below is an example of the unit in standby mode. Note • Do not remove the SD memory card until the preview is shown on the display. 5 Press the Advance Key ( ) to zoom in on the image. Note • SDHC memory card is not supported. • If an SD memory card has been formatted (ex. by the general formatting software of a computer), it oftentimes cannot be recognized by this unit. To use the SD memory card with this unit, it must be reformatted to comply with SD memory card specifications using the appropriate formatting software. You can also download the formatting software for the SD memory card from the following site: http://panasonic.jp/support/global/cs/sd/ download/sd_formatter.html • It is possible to view specific areas of the image. • The current view area is shown on the top left side of the display. Press the Set-up Key ( ) to move down. Press the Advance Key ( ) to move left. • Press the Mode Key ( ) to return to the preview. 19