Panasonic UB-5825 Operating Instructions - Page 22

Computer Interfacing ■ Panaboard Operation Panel It is possible to perform the same operations as with the electronic board control panel (page 9) from the following Panaboard Operation buttons. Note • While the Panaboard Operation Panel is displayed, the Copy Key and 2-Screen Copy Key on the electronic board control panel are used for scanning images into the computer. Panel Name Description Contrast/ Remaining Film Indicator Contrast Button This lamp indicator notifies the user when the time to replace the thermal transfer film is approaching (estimated) and of the contrast used during scanning or copying. Indicator off: Normal scanning or copying contrast Indicator on: Darker than normal scanning or copying contrast Indicator flashing*: Almost time to replace the thermal transfer film (Note that only about 15 more sheets may be copied when this indicator starts flashing.) Replacement film (UG-6001) is separately available from the dealer where you purchased your unit. * The flashing indicator will go out after the power is turned off, or the printer has been opened and closed. (When copying is performed, this indicator will begin flashing again.) Each time this button is pressed, the unit will alternate between normal and dark contrast modes (Normal/Dark). 2-Screen Scan This button scans the front and back of the screen on a Button single page. Multi-Copy/ Error Indicator Multi-Copy/Stop Button This indicator displays the number of copies to be made. The display changes each time the Multi-Copy/Stop Button is pressed. Example: 1 → 2 9 → 1 → ··· When an error occurs, a flashing symbol will appear in this display to indicate the error status. (See page 27.) When making multiple copies, press this button until the desired number of copies is displayed on the Multi-Copy/ Error Indicator. This button can also be pressed to stop copying while executing multiple copies. • The display changes as shown below each time the screen is copied. After reaching 0, the display will reset to 1. Example: 5 → 4 → 3 → 2 → 1 → 0 → 1 (Number is counted down.) * If scanning, the setting 1 to 9 for the number of copies is ignored. Scan Button This button scans the screen. 22