Panasonic WV-SW458 Installation Guide - Page 17

Preparations When installing the camera on a ceiling or a wall, there are 3 methods as specified below. • Using a two-gang junction box (☞ pages 18 and 19) • Installing the camera directly on the ceiling or wall SW458M (☞ page 19) • Using the supplied mount bracket SW458 (☞ pages 20 to 23) IMPORTANT: • Procure 4 screws (M4) to secure the camera attachment (accessory) or the mount bracket (accessory) SW458 to a ceiling or a wall according to the material of the installation area. Do not use wood screws and nails. For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for securing. (Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft}) • Mount the camera attachment (accessory) in consideration of the camera angle in accordance with the instructions (☞ pages 18 and 19). • Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more. • If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced. The mounting conditions of the camera are described as follows: Installation Appropriate mount place bracket Ceiling/wall Two-gang junction box Recommended Number of screw screw M4 4 pcs. SW458M (Direct mounting) M4 Ceiling/wall 4 pcs. SW458 Mount bracket (accessory) M4 Ceiling/wall* 4 pcs. Minimum pull-out strength (per 1 pc.) 196 N {44 lbf} 196 N {44 lbf} 196 N {44 lbf} * The conditions for securing the mount bracket to a ceiling or a wall are described here. 17