Panasonic ew3122s EW3122 User Guide - Page 9
Measurement, 2B/2B, BB:BB, On/Off, About, movement, indicator, function
View all Panasonic ew3122s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
TAKING A READING Measurement On/Off E'er I Press the On/Off Start button. • The pressure cuff will automatically be pressurized and a measurement will be taken. nnn 2B/2B BB:BB OLnInOLIrOLsI ug V :BB 111121 /no B/ 3 15:30 I LI LI 4 • If the measurement notification time is set, the bell mark 4 will be shown. (To set or check the measurement notification time, see pp. 19 to 21.) • If your body moves during measurement, the body movement indicator lamp will blink. (See p. 15.) The entire display will ight for approximately second. • If there is air left in the pressure cuff, the fully lit time will be longer. The heart mark V will blink when pulse is detected during pressurization. 2 the blood When measurement has been completed, a series of beeps will sound and Beep Beep Beep\ Beep pressure and pulse values will be displayed. L 3 color light system 1101J 140 .•HPnWty'prstetenn'dko'nn •Normal •Hypetension 4 LI r 80 •Petypedenslon •Normal 92 Skim:mast hdists • Pressure will be automatically released from the pressure cuff. • The blood pressure indicator lamps will light (for approximately 6 seconds). • If the measured value is in the high blood pressure region, the values will blink (for approximately 6 seconds). (For how to read the blood pressure display, see p. 16.) • The f';',6), marks will light. 111121 .-RetakeReading • The E mark will blink. (For storing measurement values, see p. 17.) • The pulse rate value is the beats per minute calculated based on the pulse rate during measurement. On/Off 3 preSS To switch off the blood pressure monitor, the On/Off Start button. • If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 5 minutes. 15 TAKING A READING (CONTINUED) About the body movement indicator function If your arm (to which the pressure cuff is attached), etc. moves during measurement (such as if you unconsciously bend your elbow), it may not be possible to take measurements correctly. • The body movement indicator function uses the body movement indicator lamp and a warning sound to tell you when movement has occurred or when excessive pressure has been applied to the pressure cuff during measurement. • If the body movement indicator lamp blinks, return your arm to the correct posture. (See p. 13.) • When body movement has been detected, the body movement indicator lamp will blink when the blood pressure reading appears. (The lamp will also blink when measurements for which movement was detected are stored and later recalled.) Body movement indicator lamp Warning sound display Explanation Blinking Beeeep beeeep (long buzzer sounds) Body movement was detected. • You unconsciously bent your elbow. • The upper arm became very tense. • You moved your arm. • Etc. Return to the proper posture. A movement which will cause large differences in measurement values occurred. • Body movement was large. • Body movement occurred several times. Beep beep • Arm movement was large. 0 (short buzzer Remeasure (Remeasure mark E is shown.) Lit sounds) * It will also be lit in the following cases: • Pressure cuff tape fastener became unfastened. • Tube came out. • Etc. (For details, see p. 28.) " This function is intended to help ensure correct measurements. (See p. 26.) Even if the remeasure mark does not appear (or body movement indicator lamp does not light), it is recommended that 2 or 3 measurements be taken in a quiet condition for best results. 16