Paradigm Signature S6 Manual - Page 8
If installing in drywall, thickness should be 1/2˝ 13 mm or 5/8˝ 16 mm only. Screws must be long - specifications
View all Paradigm Signature S6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
BRACKET INSTALLATION FOR ON-WALL SPEAKERS (pictorial) IMPORTANT NOTES: Please read before installing brackets Paradigm DOES NOT supply hardware for mounting brackets to the wall. Mounting hardware shown is an example only; hardware will vary depending on wall type. If installing in drywall, thickness should be 1/2˝ (13 mm) or 5/8˝ (16 mm) only. Screws must be long enough to go through anchor bolts and firmly into drywall (see Inset 1). A specific clearance is required when sliding on-wall speakers onto bracket. For more information see Fig. 8g. PARTS INCLUDED (ONE SPEAKER): • 1 - Wall-mounting bracket • 1 - Angle bracket with 2 screws • 1 - Hex key REQUIRED, NOT INCLUDED (ONE SPEAKER): • 5 - Anchor bolts (minimum load rate 25 lb / 11.3 kg) • 5 - Flathead (Countersunk) screws. (TIP: Paint to match Black speaker finish) (Note position of metal tab) Fig. 8a Inset 1 Inset 2 Position bracket for horizontal or vertical (see Inset 2) placement and mark center hole. Press anchor bolt firmly into drywall and screw in. Follow with flathead screw (see 'WARNING!' at right). WARNING! Screws must be inserted straight and fully tightened to ensure correct operation of bolts. Metal tabs must sit at outer edges (as shown) when brackets are installed vertically. Fig. 8b Fig. 8c Fig. 8d Ensure bracket is level, then mark the holes for Allow bracket to rotate clockwise, then screw in Reposition bracket as shown. Align screw holes in anchor bolts. anchor bolts. bracket over anchor bolts. Insert screws. 8